Oh man, I broke my class D amp. Make fun of me. Then help.

So... I made a new pair of super fancy interconnects this evening. Of course I was on auto pilot on the second one, especially the last connector. And, of course I always test my DIY cable projects before install..

Except tonight. Installed the ICs and all I hear is clicking. Not loud, and independent of the volume on the pre. Independent of source. Weird. I shut everything down and figure maybe, for the first time ever, I miswired a cable, so I pulled the new ICs and tested. Sure enough, I crossed my signal and ground. I repaired my mistake, reinstalled and now the amp the crossed IC went to is jacked.

The volume is much lower than the other channel, there is distortion during strong high frequency signals and the sound drops out during strong low frequencies signals. The other amp is fine. I swapped channels coming from the pre and the problem stayed with the amp. I doubt it is the speaker, as there were no sudden loud noises. Just the innocuous clicking...

So, what did I fry? Some kind of capacitor? Or everything? The amp is a Ghent audio monoblock, which is class D and uses ICEpower a/s modules. It is a GA-M500. Here’s its webpage: https://www.ghentaudio.com/amp/ga-m500p.html

I’m fine sending it in for repair, but if anyone has either knowledge of amp design or the unfortunate luck to have done this, I’d love to just fix it myself and save a lot of sending it around the world. Also, feel free to make fun of me. I deserve it. Such are the consequences of hubris.

If you’re wondering, I used KLEI pure harmony connectors, which have two identical looking tabs, one on each side, to solder the signal and ground to. If you look even remotely closely you can easily tell which is the ground.. but it’s not at bad as if I had done this with a more traditional RCA connector. That would have been really pathetic. 

Also. Recommendations for repair shops please.

Ugh.