If I could insert a bit here about clean power. Generally the cleanest power you’ll get is by using batteries. I’ve installed a couple of small standalone systems for a friend of mine who lives off the grid, and it’s a basic solar panel battery charging system. Where he can, he uses 12 or 24 volt devices so that the system runs directly from the batteries. However when 110-120 VAC is required he uses a very high end power inverter. The power inverter’s output is not super clean however, and an isolation transformer and then line conditioner is used to flatten out the peaks and obtain a true AC RMS voltage. I would not recommend a generator for your sensitive electronics unless a good line conditioner is protecting them from it. Generators provide very poorly regulated dirty AC power by nature which has lots of spikes and dips directly related to the load being put on the generator (and the motor will surge and race with a varying load). These spikes are very damaging for SMPS units such as those in flat screen TV’s and many DAC’s, or digital audio equipment. For tube gear, it can cause issues as well. If you use a generator, make sure you use some really good AC line filtering between it and your electronics. I have a Generac 5,000 watt continuous generator and when there’s a power loss I disconnect my PC and TV’s from it as well as my audio gear. I’ve repaired many TV’s for people who’ve lost them due to using a generator either in an RV, or during a power outage. Those power supplies receive a spike and usually don’t make it. Some devices can survive several such spikes, but just a caution that it does have the potential to damage electronics if/when run directly from a generator. Best, Aric