2. cables
  3. 132883-106525

Help needed for a skeptic!

I admit I am a cable skeptic and think spending $6k on a set of interconnects is loonie!
I have a set of YG Anat 3’s driven by Chord amps. I am using a Krell Foundation pre-amp. It is driven by a Chord DSX-1000. I have good hardware. I have been reluctant to spend too much on wire do to mu  meeter going off every time I look. I am using balanced interconnects. Mostly Straightwire. My question is what would those who post suggest for speaker wire. I do Bi-Amp my YG’s Right now I am using some Nordost flat cable knock offs. My sound is great but I think a little compressed for my equipment. If one were to try an upgrade on speaker wire under $1000 to bi-amp what are your suggestions?
drjsmd
chrisr's avatar
chrisr
543 posts
 
What about Van Damme Hi-Fi UP LC-OFC 6mm, or 4mm, terminated by you with pure copper BFA plugs Furez TSTSB50NP.

I would be very surprised if that does not make the best possible connection.
sc4a
28 posts
 
go to the lending library at   THECABLECOMPANY.COM


there is only one way to determine how a cable will sound in your system, play it in your system !
asvjerry's avatar
asvjerry
4,680 posts
 
...as sc4a notes, 'the proof is in the ...' cable instead of pudding....

Pudding and electronics of any sort and/or flavor is just a mess...;)

Happy New Year....and hopefully not the entire one spent on the search....*G*
randy-11
1,913 posts
 
if your sound is a little compressed, try addressing the grounds and buy an isolation transformer

after that, go to one of the rental cable places as per above
More to discover