Infinity Renaissance 90 questions

It's an age old discussion point. The safe statement is to say that any system is only as good as the weakest link. However, as a part time amplifier designer I can say that there is infinitely more scope for design variations with amps than there is with speakers, which is the opposite to what most people might expect. It's also a fair point to state the amplifier > speaker interface and the complex load presented by the speaker can and does induce distortions in every amplifier - but very differently depending on the ampifier design. This can be a huge source of confusion for audiophiles who spend a great deal of time changing their power amplifiers for the best possible result only to find after an upgrade of speakers that the amp sounds mediocre when compared with one they had previously discarded. Of course these statements are most true of low to mid priced amps but they can also sometimes apply to very expensive designs. I regard Krell highly because in my experience they produce close to the the same sound regardless of the speaker load presented. When you hear differences between speakers you can be far more certain that they are indeed differences between speakers. Not too long ago I was visiting someone who loved AR preamps. He was demo'ing differences between interconnect cables to the power amp and he believed that his AR must be better than his Krell because it was showing up big differences while the Krell did not. Of course the reality was that the different cables had very different amounts of capacitance which was exposed by the relatively high output impedance of the tube preamp. Unfortunately I was not able to convince him that this was the case. That's not to say that I don't believe that cables can make a difference but from my experince as an amp designer I have found that a small change to an amplifier gain stage - even a small change to a resistor value can result in a far bigger change than you can get by changing cables.

if you where to run your Fet nine + OCM 200 on one of those cheap speakers with all paper cone drivers, tweeter included (vintage radio shack), and compare them to the ren 90's driven by any bottom line brand receiver, i think that the ren 90's would still sound better, someone should run a blind test. LOL
greg

Timpani, what a difference a day makes in the life of an audiophile. After weighing up the benefits $4000.00(AU) was going to make to my system invested in either a line filter or in a high end re-design/re-wire & external x-over mod to my Rens, I realized ok, they're in great shape BUT they are 14 years old, and wiring and caps would have degraded to a certain extent...added to which, that's an opportunity to replace $8 per meter internal cable with $800.00 per internal wire & replace the 5% standard value caps with the best sounding sounding caps around. All the comments from IRS-Sigma owners I admit at first made no sense to me, but with your clarification, yeah obviously their superior crossover does make a noticeable difference. The re-design I am planning however is on a much higher order & results should be stunning. The new x-over will make the Rens more efficient as well. This is significant in itself in with this mod, I should be able to achieve the same stunning results as guys like Clavil running a single big iron amp & pre. I think that is a smarter solution to bi-amping, do you agree? And yes, I will proudly wear my gold medal for the backflip, thank you!

Hi Melbguy,

I actually responded to you on AK which you will see before you read this but it was without the benefit of your latest comments here. IMO 4K on a line filter is insane but even more so in your case if you buy the Classe CAP because it is so well designed. Read my other comments and digest them. The mods will work out fine if your AE knows what he's doing but the best approach - be it single or bi-amp may not be apparent until the design work is partly underway. I'll explain further tomorrow.