SQ : Anthem receiver vs. processor

Hey Caphill!
That's really interesting about the Classe amp! I'll do more research before deciding.

Best,
E

I've been reading a little bit about the Classe Sigma Amp5.
It's an interesting creature. Completely in house design, and, unusually, it is a true Digital Class-D amplifier, as opposed to an analog Class-D.

So, sadly, all incoming analog signals are converted to digital, signal processing to compensate for the amplifier stages and aging is applied, before it reaches the outputs.

Still, as a small high end HT solution it looks very interesting!

@erik_squires

Re : Classe Sigma class D amps, I’m not so sure if the incoming analog signals are converted to digital upon input but I know that Classe uses DSP to regulate the amp. It is Classe’s proprietary class D design.

I don’t use Classe Sigma Amp (class D) to power my front and surround speakers in my dedicated HT room but instead I use the Classe Sigma Amp (class D) only to power my overhead ceiling Atmos speakers for Atmos setup in my dedicated theater room.
I use all Classe Delta series class AB analog amps to power my front LCR speakers and surround speakers. I’m using 3 Classe Delta CAM-600 monoblock amps (class AB) to power my B&W 800 D3 front speakers and the matching B&W HTML1 D3 center speaker. Using 2 Classe Delta CA-2300 stereo amps (class AB) to power my surround and surround back speakers. And using 2 Classe Sigma Amp2 stereo amps (class D) only to power my overhead ceiling Atmos speakers for Atmos setup.

You can email Classe technical support group and ask them and confirm the info with them.

However, I’ve heard the Classe Sigma SSP paired with the Classe Sigma Amp5 class D amp before at the store and they sounded great together especially if you like class D design amps. But when I heard the Sigma SSP paired with the Classe Delta series class AB amps they sounded better for sure. The Delta series class AB amps had more body volume and fuller sound than the Sigma series class D amps. Had more mid-bass and bass power too and sounding more punchier and much quieter design than the Sigma series class D amps. The Delta series class AB amps, especially the CAM-600 monoblocks, are indeed better amplifiers overall than the entry level Sigma series class D amps for sure but cost much more than the Sigma series class D amps. They aren't in the same league.
That’s all I can say.

@caphill The proof ultimately is in the playback. :)

I want to keep my Mytek Brooklyn in the mix if possible. If the ultimate amp is going to do an A/D conversion on input it kind of defeats the purpose.

I miss my Theta Casanova. The DAC was so good, and A/D so good I truly did not care.

@erik_squires 
  it sounds like you will continue to use your Brooklyn for music. My advice would be to go cheap with an AVR.  The most demanding requirement for AVR is music reproduction.  Most AVRs in the $500 and up range do a decent job with dialogue, explosions, etc and let the video processing be done by the player.  Make sure your AVR or processor will handle a 4 or 8 K display or whatever you are using.
Another advantage of going cheap is that in a couple of years as Tecnhnology advances, there might be an AVR or processor that will have a DAC that will top the Brooklyn, and you will only have to make one move to upgtade.