Being an industrial electrician dealing with mostly lethal high voltage lines of 480v I might know a thing or two about being careful concerning electrickery.
I would likely agree that the largest hurdle here would be persuading a reputable outside electrician in a state that is very code conscious that it is "ok" to wire this into the main panel without a bit more than your say so that it is fine.
Best approach would be just do it yourself paying due diligence to your own health and safety.
As I obviously would do this in a heartbeat I am not at all concerned but can concede the point.
Would not be the first time I had been presented with a piece of equipment on site with zero paperwork or electrical prints and been asked to "just wire it in"
Uh uh, no way Jose!
However we are talking 480v and 1200a plus applications, something that will pick you up and throw the leftovers across the room if you screw up!
I would likely agree that the largest hurdle here would be persuading a reputable outside electrician in a state that is very code conscious that it is "ok" to wire this into the main panel without a bit more than your say so that it is fine.
Best approach would be just do it yourself paying due diligence to your own health and safety.
As I obviously would do this in a heartbeat I am not at all concerned but can concede the point.
Would not be the first time I had been presented with a piece of equipment on site with zero paperwork or electrical prints and been asked to "just wire it in"
Uh uh, no way Jose!
However we are talking 480v and 1200a plus applications, something that will pick you up and throw the leftovers across the room if you screw up!