Trying different output impedance taps with tube amps


My Antique Sound Lab Tulip 2A3 SET amp has 4, 8 and 16 ohm taps. I had been running the 8 ohm taps, and had a friend over to listen. He suggested the 4 ohm taps might be a better match for my speakers (Audio Note AN-Es). He was right, and it made a really nice improvement.

If you have multiple taps on your amp(s) and have never tried the other ones, or haven't for a while, it's worth a shot. Even if you are using the recommended or “right” ones for your speakers, you might be surprised.
tommylion
I'm in agreement with those who advocate trying all the available amplifier taps and listen.  Each circumstance will be different and it's difficult to generalize if higher or lower tap is superior.   My amplifier has 8 and 16 ohm taps and my speakers are 14 ohm nominal.  I've tried both taps and  the 16 ohm tap offers cleanly the  better sound quality. 
Charles 
bdp24,
I believe that Ralph has pointed out in the past that using the higher ohm tap results in less distortion, increased bandwidth and better efficiency.  
Roger Modjeski is definitely  a proponent of the "light loading" approach. Honestly it depends on the particular amplifier and speaker involved. My SET amplifier has no NFB  and this probably explains the better sound quality with the higher 16 ohm tap.
Charles 
My Quad ESLs (1957) need 16R taps on my tube amps with 8 and 4 ohms sounding progressively duller and colored. The difference is night and day. I guess it limits them to amps with 16 ohm taps.
My zu druid V speakers sound much better with the 8ohm taps on my prima luna HP.  It's not even close.
I only have a 16 ohm tap on my old OTL tube amp and I am using a 16 ohm broadband loudspeakers from Ocellia. So I can’t compare, but I can say is that this works very, very well.