VPI Cuing arm falling too fast

 What’s interesting is the one I have, which is the silicon, isn’t hydraulic at all in any real sense, it seems like it operates from a stiction standpoint. The thickness of the silicon slows the fall of the piston. 

@slaw, you assume to much, still laughing even harder now. Thank you

If the cuing doesn't raise high enough....it can be adjusted with an Allen wrench to raise/lower the whole cueing assembly.....if that doesn't do it, you should lower the arm by lowering the arm pivot itself....easily done.  Let me know if you have question.

Thanks to all for this, particularly @dodgealum.  I had a Scout 1.1 with the damped, long and thin lever which I liked, then got a Scout Prime with the short, mechanical, be very careful lever. Wondered what was going on....I think I am used to the manual one now.