Which Stands for Magnepan LRS (and other models): Mye, Magnariser, Sound Anchor, etc

Ok. magna riser, you present a compelling argument, and quite frankly the neither the mye or sound anchors sound like their designs are really perfect for the LRS.  So should I consider one of the three current stands that works for the LRS, or should I be patient and wait for the stand specifically designed for the LRS?

I never tell anyone that Magna Risers are the best or only aftermarket stands worth considering. I do think that they are certainly among the most well researched. I have tried different metal types, gauges, and geometries, combinations of different type metals and experimented with alternate materials such as carbon fiber, kiln dried woods, and composites. We experimented with heat treating, shot peeing and even stress relieving bulk metals. Some of our models use constrained layer dampening, tuning blocks or resonance tuning plates and dampeners with interference fit. Some use 6 different build materials in combination and take more than 20 hours in the build process. Each is resonance tuned in an extended listening session that can be as long as 4 hours. Every change in design made a difference, some for the good some with negative sonic contributions. In the end I dial in the combination that allows the stands to enable the speaker to more fully realize the inherent potential of the specific Maggie model while maintaining the “Maggie Magic” while also providing for improved style and stability. These are limited edition built to order stands. You can check out our three LRS designs on our magnarisers.com website and see think pieces on our designs over at our Magna Risers Facebook page where you can request a list of owners comments. We have dozens of stands on LRS’in owners homes and none has been returned because owners could not hear the sonic benefit of having them in their system. In fact some owners write saying I should charge more. In the case of the new yet to be constructed LRS stands mentioned earlier I will say that they may not be available for quite some time and also give you a heads up that the cost will of necessity, because of the added complexity of the design and use of expensive exotic metals, be significantly more higher priced than the cost effective pricing of our three current offerings.

Hmm...

A manufacturer openly promoting his products here, that's new.

They appear to be good products, but really?

MODERATOR???!!!

I don't own Maggies but if I did I would would either have them "gunned" or get Magna Risers. Rob recently made me a set of risers for my Acoustat Model 2s. It took a little while for the work to be completed due to it being a custom job he took on, but Rob was very communicative through the entire process and the work was first rate and quite economical.

Clio09-  what is “gunned”?