Transformer coupled vs Capacitor coupled?

I believe it is Ralph’s contention that balanced circuits themselves provide benefits over single-ended, Tim and Roger that balanced transmission is what they find of significant value, not the circuit itself. About that I may be mistaken ;-) --- Eric.

I doubt that either Roger or Tim would deny the benefits of balanced differential circuits- in a nutshell, rejection of power supply noise and also rejection of noise induced in the interconnect cables.
A secondary benefit is lower distortion as even ordered harmonics are cancelled with each succeeding stage. This means that the primary distortion product is the 3rd harmonic, which is treated by the ear in a similar manner to the 2nd (contributes to 'warmth' and 'bloom') but its level is at about 1/10th of a circuit that has the 2nd harmonic as its primary distortion component. So distortion components are not compounded from stage to stage as the signal progresses through the signal chain- this results in less coloration.

Basically it comes down to implementation of the design.  All of the designs have their benefits and detriments.  Coupling capacitors have a wide bandwidth but can give up dynamics, details, and transparency to transformer coupled.  With transformer coupled you can get fantastic sound at 20K but designs up to 40K is even better.  They look pretty bad looking at the square wave but you do not need 100 to 200hz to make them sound fantastic.  I have built both (and own both) and the transformer coupled just has more transparency and details.  I use V-Capacitors in the preamplifier as I prefer their sound to the others we have tried.  The Servo design also depends on the implementation.  I have heard some that sounded very poorly but the old Luxman power amp that I have is just incredible.

So is one better sounding than than the other - to me again design implementation is the key but each has its benefits if done well.  Coupling caps is a much easier design to implement IMO.

Happy Listening.

Sound quality
1st Direct coupled using a good dc servo (most transparent/dynamic)
2nd a Good quality Cap (large enough not to roll off the bass too early)
3rd Transformer coupled (using good transformers)

Cost to make, lowest first.
1st Direct coupled ($10-20)
2nd Cap coupled
3rd Transformer coupled.

Least distortion/coloration’s (lowest first)
1st Direct coupled (always lowest, if good design)
2nd Capacitor coupled
3rd Transformer coupled

Lowest output impedance (good to drive next piece of equipment)
1st Direct coupled (lowest from DC to wherever)
2nd Capacitor coupled
3rd Transformer coupled.


No-brainer, direct coupled wins out, cap comes in second.

Cheers George

Guys,

This is awesome and at some point would like to hear a direct coupled tube pre in my system! From my basic research, it's hard to discern if the pre is direct coupled on both in/outputs or if the transformers used are capable of a wide bandwidth; seeing vague terminology...

C or EI cored signal and power transformers are phenomenal but are pricey and would cost almost half of the cost of the pre if they are truly direct coupled.

I know it going to be a costly adventure and knowing that it's solidly designed with quality parts and layout may make the journey worthwhile.

Now the question still remains if more dynamics or transparency will come through as brightness or more forward sounding compared to capacitor coupling? But I guess one can still tube roll in pre or amp to attain the sound they prefer knowing that it's a much quieter pre : )

Wig

wig OP
This is awesome and at some point would like to hear a direct coupled tube pre in my system!

I believe from what he says, "maybe" Atmasphere’s pre "could" be "direct coupled from input to output" ask him precisely that.
I can’t believe there’s no coupling cap/s somewhere between input and output somewhere.
But then it’s a shame if the rest of the system is not true direct coupled also?

C or EI cored signal and power transformers are phenomenal but are pricey and would cost almost half of the cost of the pre if they are truly direct coupled.

Don’t get into the thinking that "coupling transformers" and "coupling caps" are some kind of "magic music making components", their not, they are in many designs a necessary evil to have. Proper direct coupling using a good dc servo control, nails them every time in all avenues of music reproduction except for one "coloration".

Cheers George