2. misc-audio
  3. 154519-71509

Damping Plates

Lots of discussions about isolators and couplers used on the bottom of components but not much said about dealing with internal resonances using damping plates on top of the equipment. Harmonic Resolution Systems (HRS) is one of many manufacturers that make such devices but, like all things with an audiophile label, they can get expensive. Low-cost alternatives such as scuba dive weights have been mentioned by some.

Have you tried damping plates and were there worthwhile improvements in sound quality?
turnbowm
mijostyn's avatar
mijostyn
8,570 posts
 
Really? First you have to control the magnetic flux surrounding your ears so that it is perfectly symmetrical. Take any headband and using silicone glue two one inch neodymium magnets right above your ears. Amazing. And you won't have to worry about dripping sweat on the record.
jtcf's avatar
jtcf
1,617 posts
 
My MicroZOTL2 benefits greatly from damping.Isoacoustic footers helped and two pounds of weight on top changes the sound for the better in this lightweight component.I'm currently experimenting with materials and figuring out how to incorporate a damper that's not hideous.The bayberry jar candle works well,but looks ridiculous:-)
ebm
9,311 posts
 
VPI and the small HRS also Symposium makes some great ones they are best less damping is always better.Dive weights is a big cheap joke.
lowrider57's avatar
lowrider57
5,417 posts
 
On equipment with contiguous top plates (no exposed tubes)  I spray painted 2.5 and 5 lb. bar bell weights and glued a thin cork sheet under.

@mesch , great minds think alike. I needed to damp a new  component but didn't want to spend any more money so I used 2.5 lb. weights and added a cork bottom.

 

mesch
3,481 posts
 
@lowrider57 which base type do use on your Edensound brass damping discs. I would want to keep than from sliding on surface of any component with exposed tubes.  
More to discover