Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

@charles1dad The EML SPs replaced the JJ 40s Scott’s Found-Music 2A3 amps came with (per the seller’s offering). In other words not stock. Buyer would specify if the amps were to be purchased new.

Not even close, in terms of my preference for the EML SP over the JJ 40s. Having said that, my amps / system sounded very good with the JJs. They are a terrific value.

Hi David,
Okay,  "you've been there and done that" with regard to comparing the two 2A3s. So much for that😀. The EML is much more expensive and their performance should reflect that. Based on my experience with the EML XLS 300b I can vouch for the following 
Excellent sound quality 
Exceptional reliability 
Very long life span

The EML 2A3 should no different.
Charles 

@ david_ten

Thanks for the 2A3 comparison and I will be on the look out for a pair on the used market, hopefully something will show up... : )

Wig

@ david_ten

Is there a big difference between the EML Mesh and Solid-Plates? Maybe the type of music one listen to is the driving factor on tube type...

Thanks,
Wig

@wig I did not compare the SP to the MP, so I cannot address directly (in terms of experience within my system).

There are other members who know much more about this than I do. @charles1dad is one of those members. I’d reach out to him as he has compared both directly.

My understanding is that:

- the SP has a much longer lifespan.
- the MP needs proper care in matching / compatibility (electronic reasons) with one’s amp.
- there are more reported "reliability" issues with the MP, however this is mostly due to improper matching.

- the MPs have been described to me as being more "ethereal" "extended" "airy" and generally more "glorious" and "magical" in the mid-range over the SP.
- the SP has been described as more "linear" more "neutral" more "robust/dynamic" more "authoritative" and stronger in low frequency performance (versus the MP).

Both are very good options and one’s system’s needs and preferences should, as always, serve to guide a choice between the two.

I was advised to get both. I haven't procured the Mesh Plate version, as of yet. 

[Note: the descriptors used are relative and for purposes of "highlighting" differences]