Aesthetix! Tube front end SS driving the load - pairs very well with ARC front end, made in USA, Jim White is a real engineer with ears, try to buy the signature version.
Suggestions please!! --Need to replace vintage Audio Research VT 200 Tube Power Amp
I have a nearly 25 year old ARC VT200 amp, which just arc'd out on me for the 3rd time in 18 months, and I have decided I cannot sink any more money or aggravation into this amp. I purchased it used about 7 years ago, and it had just been re-tubed, and it ran problem free for me for over 5 years. Then without warning it arc'd out, resulting in a replacement of all tubes, capacitors, etc. 10 months later, the same thing happened again. I nearly bailed on it then, but the repair shop assured me that they could "really fix it" this time, blaming the repeat issue on the need to replace all of the tube sockets and repair some thinning wiring, and they assured me it would be "like new" and should run problem free for years to come. It's been 9 months, and it's been running fine with relatively light use (probably 300 hours since the repair) and last night the fireworks happened again. Needless to say, I've now reached the end of the road with this amp.
So my questions are these--as much as I loved the amp (when it was working!) a comparable new ARC tube amp (which appears to be in the $15k+ range) is out of my price range. The VT 200 is currently paired with an ARC Reference 2 preamp and a tube ARC phono stage from the same era, which are working fine, and they are driving a massive pair of ProAc Response Four speakers. I listen almost exclusively to vinyl on a VPI turntable. Does anyone have a suggestion for a new power amp for under $10K (after this experience I am reluctant to go the used route)? Also, would it be OK to pair a solid state amp with these tube components, and if so, any recommendations? Thanks!!
So my questions are these--as much as I loved the amp (when it was working!) a comparable new ARC tube amp (which appears to be in the $15k+ range) is out of my price range. The VT 200 is currently paired with an ARC Reference 2 preamp and a tube ARC phono stage from the same era, which are working fine, and they are driving a massive pair of ProAc Response Four speakers. I listen almost exclusively to vinyl on a VPI turntable. Does anyone have a suggestion for a new power amp for under $10K (after this experience I am reluctant to go the used route)? Also, would it be OK to pair a solid state amp with these tube components, and if so, any recommendations? Thanks!!
- ...
- 25 posts total
unless you are playing in a church or auditorium, those speakers, no way do you need that much power, they are 89 spl efficient, and 8 ohms. https://www.stereophile.com/content/proac-response-4-loudspeaker-specifications I would say 75wpc is plenty, perhaps even a bit less. Do you have a friend with a low powered tube set, i.e. 35wpc? just try that, to establish a comfortable minimum, you will be surprised. New or used, just make sure you can return what you try. |
- 25 posts total