Experience with Inakustik 3500P Power Conditioner??

@mike_ostradick That is my guess as well but I don't have another 20amp power cord. I've reached out to Bob to request another cord and hopefully if he can accommodate. Do you know if he does the actual termination? I read somewhere that is the case but it is strange if he needs to build the cords.
@milpai Thanks for testing your unit and glad your's is showing up correct. Btw, will you be upgrading to the 2404 Air cord? Bob mentioned it would enhance the 3500P...
-Alex

If you have a multimeter we can compare the pinout on your cord to mine and others.  

@mike_ostradick I don’t have a multimeter but happy to buy one if you let me know how to use it and perform the test. -Alex

@rareace,You are welcome. Absolutely no intentions of upgrading anything at the  moment. Last week I upgraded my Clear Day XLRs (2 pairs) to Inakustik NF-2404s. If I upgrade anything more, my wife will upgrade me as well :-) Took me more than 2 weeks to convince her why I wanted the XLR upgrade so badly.

I don’t have a multimeter but happy to buy one if you let me know how to use it and perform the test. -Alex 

Alex - It is a simple continuity check you want to test between each pin of each connector.  Any cheap multimeter that you can get at Home Depot  or Lowes or possibly even WalMart will do a simple continuity check.  Usually they have tone confirmation for continuity check so I usually try to get one that has that at a minimum.  

I just tested two different C19 cables I have and found the following results.  I held both plugs in my hand so the male/female ends were pointing at me with the two pins on top and the single pin on the bottom.  On each the same position pin on each plug had continuity to the respective pin on the other connector.  Top right was connected to top right on each connector.  The only thing that could get reversed is the top two pins to give you the off reading.  The single pin should always be ground. 

Good luck.