Behringer DEQ2496 HELP

I had the same problem when I first got mine and managed to solve it, but now I can't remember how. I will try to figure it out, but I think it has to do, as someone on AA suggested, with the overall gain settings you establish. Ambient noise does tend to be greater than you'd expect, at least has been when use the unit in my system. You may have overall gain set too high.

I think there would be a small but enthusiastic market for "DEQ2496 for Dummies." I'd pre-order and pay a premium, LOL.

Thanks Drubin. I wish to emphasize that the sound out of the speakers is loud when it says Ambient. This is most weird and certainly not desired behavior. Then, a few seconds later, when it states it is measuring Pink, it seems to me that it is adding a layer of a slightly different pitch on top of that sound. How loud is the original sound? Loud enough to be heard from two rooms away. Definitely NOT an oversensitive mic, as the sound itself is the issue.

Hope you and/or others can help me get this solved. I have sent an email to Behringer as well.

Kck...When measuring ambient noise (in the home environment) it should be dead quiet. I think that the ambient noise measurement may be important for pro sound applications where things may be going on while the sound guy is trying to get set up.

You might try using the analog output of the DEQ2496 into your amp. The D/A in the Behringer is probably as good as the one in the CDP, and one less item in the chain might help to isolate your problem.

Eldartford is right - there should be no sound out of the speakers when measuring ambient noise. Check your I/O menu and make sure you're not sending the mike signal to the outputs.

Thank you to the posters so far. Late last night, I had to try it one last time before going to bed; it was really bothering me. I experimented with the inputs...DUH! (hand slaps head).

I needed to put I/O on page 1 (input) to Pink Noise, not one of the others (I had optical). After this, it worked well enough for me to know that it will do the job, but I was beat and had to go.

I did let it run for a bit though, and it (the pink noise) seemed to go on for a pretty long time; I would guess at least 5 minutes. Is this expected/normal? The curve looked fairly different after but as I said, I had to go.

Thanks again! I look forward to playing some more tonight. I would also like to know if anyone has used analog in and/or out to the DEQ. I have seen many threads stating that digital IN is its strength, and I realize that, but curious if anyone has tried the analog with satisfaction. Reason I ask is I will be getting an integrated with a tape loop so that I can get all my sources on this machine, but with the easy ability to bypass it with a switch. (I think the bypass on the DEQ software is pretty easy too though).