Let me apologize about my posts. I was thinking about the f110 and spoke, in error, with regard to the e110.
I have asked the moderators to delete the posts.
I have asked the moderators to delete the posts.
Subwoofer. Great one song. Not so great the next song.
I'm not a subwoofer guy. Played around with one in my primary system (Aerial Acoustics 7Bs, Proceed 250w amp, AR LS-16 tube preamp). Big B&W powered, not sure which. Didn't think it added anything. Ditched it.
Recently got a pair of Aerial Acoustic 6Ts for my secondary system. They have no place to be but right up against the wall. Maybe a foot out. Can't decide if they sound better with a sock in the rear facing bass port or not. Its a wash. Overall they sound pretty dang good though.
But, I played around with a JL Audio e110 sub. Pretty nice unit. Put the socks back in the bass ports.
On some songs the combo with the sub just sounds stellar. On others it sounds boomy and thumpy. My audiophile hang up is taught, clear, concise bass. I do not like boomy and thumpy at all. I can get up and turn the output on the sub down a little and it sounds okay again.
But I don't want to do that every time a different song comes on.
Now, on this sub you can change crossover frequencies, phase and also a polarity switch. I don't know _anything_ about that stuff. I've got it set on the more or less default settings in the manual. The only thing I've messed with is the polarity switch and for reasons I don't understand it sounds better on 180 than 0. I have not messed with the crossover frequency and phase dials.
Is there any chance that changing any of those settings would allow me to reach a sweet spot where I don't have to change settings on the sub frequently? I may or may not keep this sub. If I can't find that sweet spot I'll let it go as alone the 6Ts don't sound bad by any measure.
Thanks,
George
Recently got a pair of Aerial Acoustic 6Ts for my secondary system. They have no place to be but right up against the wall. Maybe a foot out. Can't decide if they sound better with a sock in the rear facing bass port or not. Its a wash. Overall they sound pretty dang good though.
But, I played around with a JL Audio e110 sub. Pretty nice unit. Put the socks back in the bass ports.
On some songs the combo with the sub just sounds stellar. On others it sounds boomy and thumpy. My audiophile hang up is taught, clear, concise bass. I do not like boomy and thumpy at all. I can get up and turn the output on the sub down a little and it sounds okay again.
But I don't want to do that every time a different song comes on.
Now, on this sub you can change crossover frequencies, phase and also a polarity switch. I don't know _anything_ about that stuff. I've got it set on the more or less default settings in the manual. The only thing I've messed with is the polarity switch and for reasons I don't understand it sounds better on 180 than 0. I have not messed with the crossover frequency and phase dials.
Is there any chance that changing any of those settings would allow me to reach a sweet spot where I don't have to change settings on the sub frequently? I may or may not keep this sub. If I can't find that sweet spot I'll let it go as alone the 6Ts don't sound bad by any measure.
Thanks,
George
- ...
- 37 posts total
| Post removed |
George, if you are constrained with placement options and number of subs (two is better, a DSA is best), this little dsp device works wonders: http://www.dspeaker.com/en/products/anti-mode-8033.shtml You will notice a virtually complete elimination of the room modes (causing the boomy bass). Connection wise you run your speakers full range and insert this little unit between line out and sub. Good luck. |
- 37 posts total