Balanced Audio Technology MK-30 tubes. Alternative to Sovtek 6922


I just picked up a MK-30, that had been checked out at BAT in 2017 with a clean bill of health. Receipt says "clean and clear".

But on my efficient Tekton Moabs, the tube noise is very audible at the listening position. So much so, I can not use this preamp. I am debating on just reselling it, or trying new tubes to see if the noise goes away or at least down. The Sovtek 6922s are now hard to find from any reputable source, what is a good alternative. I don't need the best fanciest NOS tubes, just a good solid performer.

Any suggestions?
128x128brad1138
Thanks,
My worry is the tubes won’t solve the issue, and I will be out more money. From Upcale Audio, there are 3 options; Gold, Platinum and Kevin’s Stash. Which would you go with?
Some in another discussion are saying it could be dirty power that the tubes are sensitive to, but none of my other stuff is. My systems are dead silent (aside from this). I have tried the MK-30 in both my top 2 systems, same prob. Other equipment, PS Audio, Mark Levinson, Moon...etc.
Ting each tube with a pencil tip and see if it's sensitive to the taps. You might get away just replacing that one. 
Tubes are graded better when they are lower noise and more closely matched. It sounds like you only need lower noise.

I would call Kevin, Brent Jessee and Jim McShane and explain your problem. I think any of those three will be honest about whether they have tubes that will solve your problem, within your budget.  If they don't, sell the preamp.

First off I’d give BAT support a call. I’ve had several BAT amps. all are balanced and spurrious noises are routinely absent. I rolled tubes in an older vk5 pre and in a vk60. noise was never a consideration while interjecting different tubes. consequently I feel the issue is elsewhere…. more than likely.

however the tube replacement options are immense. 6DJ8, 6922, OR 7308 ARE PLUG AND PLAY REPLACEMENTS.

to verify the issue is in fact tube related merely buy any actually ‘new’ ones regardless brand and plug ‘em in. I should think BAT offers something here too, but finding something kshould not be difficult.

BAT amps are all self biasing so even if the what ever tubes are not new for example, things ought to reveal if a tube issue or not.

and I’d call BAT about this anyhow. hopefully it is merely a poor tube.

the flip side of the coin does seem to obligate the seller to explain their notice of ‘clean and clear’ IMO. Very good luck to you..