2. analog
  3. 162378-93252

Technics SL-1200GR setup question

Hey A'goners,

I recently purchased a Technics SL-1200GR TT and am very pleased with it. I purchased used and it came with a Denon D-110 cart.

My understanding is that when the VTA is properly setup, the tonearm should be parallel with the surface of the record. In my case, the arm tilts down slightly. In other words, it's higher in the back and lower near the cart. The tonearm adjustment is as low as it goes. If I lift up the tonearm to make it level it is probably a good 1/4."

Does anyone have any suggestions here? Is this common or an acceptable degree of tilt? I don't think a shim is going to get 'er done here. 

I appreciate any and all suggestions. 

Thanks,
Joe
audionoobie
cleeds
6,271 posts
 
chakster
... the arm must always be somewhat higher at its rear end (the counterweight end). A 9 to 9.5 inch arm around 7 - 9 mm higher. This improves the resolution a lot. Works with any arm and any cartridge ...
Ugh.
I’m sure the added distortion is likely to offer more of that warm, tubey-like analog sound. Some people like that.

I prefer neutrality, and have found a phono cartridge manufacturer’s VTA spec - typically around 22 degrees or so - yields the best result. In practice that means the pickup arm is level or very nearly so.
chakster's avatar
chakster
6,144 posts
 
Both statements made by A.J. Van den Hul, not me.


cleeds
6,271 posts
 
Oh understood, @chakster, I should have made that more clear in my post.
ericsch
767 posts
 
To the OP, this mat comes in various thicknesses at a reasonable price. I used Herbies mats when I had a Rega TT.
https://herbiesaudiolab.com/collections/turntable-mats/products/way-excellent-ii-turntable-mat?varia...

I have a SL1200G with Hana SL and the arm is practically level.
   
noromance's avatar
noromance
10,190 posts
 
I always run arms a little higher at the back. It does increase resolution. If it sounds good and distortion free, it's fine. 
More to discover