2. speakers
  3. 1325385077

Efficient speakers with high powered ss amp?

Relative newbie here, so forgive me for the stupid question. I'm wondering if, in general, it's a mistake to mix 100 watt+ per channel amplifiers with efficient speakers. I know that low powered tube amps need efficient speakers, but do efficient speakers then necessarily perform better with less watts?

I'm looking for speakers that would be a good match for my Odyssey Khartago, and have always been under the impression that higher efficiency speakers are better than inefficient speakers. Would a 98db, 200 watt speaker be ok with the 110 watts per channel Khartago, or should I look for something less efficient.

Apologies, I tried using the search function to look this topic up, but didn't get any results, so I appreciate your thoughts and advice.
rischa
unsound
7,329 posts
 
Rischa, obviously Audiogon offers audiophiles a great opportunity to buy and sell gear in their quest for optimal sound.
morganc
255 posts
 
Rischa,
I have a pair of Pendragons on the way, and Eric loves them with solid state amps. I also had a Pass XA30.5 with my Zu Omen Defs and I wish I had it now. It was a great amp!
bradluke0
163 posts
 
Hi all ! One thing I have learned , you never know what it will sound like until you try it . I was driving a pair of Thiel 1.6's with a Cary V12 and it sounded nice ...especially in triode mode . Many folks were convinced it would never work , bad drop to 3 ohms ,etc. Moral is.. try it ya never know .
mapman's avatar
mapman
22,098 posts
 
"you never know what it will sound like until you try it "

That is undeniably true.

After a while, with some experience, there should be fewer surprises though.
sebrof's avatar
sebrof
835 posts
 
Like Bradluke0, I have run my Lores with a 4-watt SET, a 150 watt SS and now a 20/40 watt Manley Stingray. Different flavors but sounds good with all those amps. I believe that it's mostly due to the Lores being such an easy load that amps loaf along and sound their best.
More to discover