I came very close to producing a speaker for production, a 95db 5 ohm 15 inch 2 way. I wanted a very high value speaker and I looked long and hard at producing high quality sound while cutting cost where I could. I built 4 different prototype cabinets trying very hard to get the cabinet stiff and inert while keeping cabinet weight down. Everything is a balancing act.
I've sat in front of a couple of Tekton speakers, he does use cheaper parts and he does cut cost on cabinets, but they are well thought out, well designed speakers. I'm sure that if you wanted to drop and extra grand or two into a given model that Eric would beef up the cabinets and improve crossover parts for you. I doubt that he would change drivers, that would require a whole new design, but if you would want to pay it, I'm sure its worth asking. I hope this explanation might help a few of you out there. Tim
I've sat in front of a couple of Tekton speakers, he does use cheaper parts and he does cut cost on cabinets, but they are well thought out, well designed speakers. I'm sure that if you wanted to drop and extra grand or two into a given model that Eric would beef up the cabinets and improve crossover parts for you. I doubt that he would change drivers, that would require a whole new design, but if you would want to pay it, I'm sure its worth asking. I hope this explanation might help a few of you out there. Tim