Over loading?

I (personally) ran 8/3 from my main, on a 60 amp breaker at a length of 20’ to my subpanel. Now, if the 12/2 from the subpanel to the outlets are nor more then 3’ per outlet x3. This is why I’m asking; I don’t want to harm my amps.

Mark, why is it weird, 12g wire is fine for 15 amps. When doing lighting, 14 is code, outlets get 12g. If you read the entire post, I wanted to segregate my tube amp & power conditioner, which now share a 15amp socket & breaker.

I've seen this before where a 15 circuit had a mix of 14 ga and 12 ga wiring. It was just a caution to you to check as a 20 amp breaker would not be a good idea in this case.

I grew up in NYC, & the stuff I've seen in my days, still give me the chills. :)

I guess I'll just leave it for now, in the event I trip the breaker then I'll change it, or add anther line. Thanks 

I just double checked my panel and it's 12awg on the breaker I changed to 20amps. Same wire is used for the kitchen which has 20amp breakers. I don't know what the run length is but it's closer to the panel than the kitchen...