XLR cables for component connections, or from preamp to powered subwoofer

I prefer to make my own from pure silver and Neutrik with silver contacts.

Yes, it’s fine if the wires are very thin. The cable I’m recommending is very good but can be brittle. Cheap enough you can build a pair and compare to the Mogami/Neutrik Mike is recommending, above.

Thank yous to @erik_squires ​​​​@mike_in_nc 

My eyesight, dexterity and confidence rules out doing some things I would have attempted a few years back (such as making my own cables).  Your answers were very helpful--and I had already presumed the cables mentioned from Amazon probably would be a fine choice for my location / conditions.

Cheers to all !

IF your equipment utilizes the official balanced wiring scheme (AES47), balanced cables should exhibit little coloration, so there shouldn't be much difference between brands.

I got some inexpensive cables from Ralph Karsten. I think they were Mogami. I needed 25 feet or so.

Years later, I tried some Audioquest- at a much higher cost, only to find they sounded almost identical.

YMMV

Bob

@hz79hc - For components, take a look at Zavfino products that use OCC copper as a minimum e.g.

The Fusion - Solid Pure Silver & OCC Copper - ZavfinoUSA

- these would provide stunning dynamic performance 

- but they only come in 1.5 meter and 2 meter lengths

Regards - Steve

is it possible to remove this duplicate post. 

Click on your user name on the top right corner of the screen then go to "My Profile" and click on "Discussions started" use the ✷ function to delete the duplicated one.