Streaming Sound Quality - Want the very best sound quality? Network Acoustics ENO...


Like many of you fellow Agoners I am striving to get the best sound quality out of my digital streaming front end. To that end I have invested in various high end switches, re-clockers, ethernet cables, various USB filters/re-clockers, high end servers and delved into fiber optic conversion configurations. All of these measures did improve sound quality at varying levels. I felt my system sounded as good as a decent CD transport on many streaming recordings in Qobuz. However, I still felt there was something missing. I felt my system was still being held back. You can see my system under virtual systems here.

Well, I stumbled across something that has finally enabled my digital system to be all it can be. I cannot fully express the level of sound quality improvement realized with the addition of the Network Acoustics ENO Ag filter and ENO Ag streaming ethernet cable. It has been 10 days now since I added these to my system and I can now confidently say my streaming and system are all they can be sonically.

Here is the set up that has caused me to sell off and move past many other powered filters, reclockers, fiber optic options, and other streaming tweaks and gadgets. Frankly, the ENO additions are miles ahead of these other options sonically in my system and experience. Miles. This is my personal experience and please understand this perspective.

Netgear NighHawk modem/router power by an LPS > Supra cat 8 ethernet cable > English Electric 8Switch > Network Acoustics ENO Ag streaming cable > ENO Ag ethernet filter > Innuos Zenith III > Mojo Audio Evo dac

The English Electric 8Switch is also wonderful. Will a lower cost, standard switch sound as good in this set-up? Not sure as I have not tried. I am so ecstatic with my sound system that I don’t want to touch it!

There is a certain rightness from top to bottom that’s intoxicating. The tone is so beautiful and natural with no hint of electronic glare or digital artificiality. Music flows with far greater ease and has an uncanny, unforced nature to it. The stage is far deeper with the music flowing from a plane that is layered and completely separate of the speakers. This aural sensation, at this level of nuance, is new to my system and experience. The ENO products made this possible.

Instruments are presented with a new realism that is arresting to my senses. There is a wholistic presentation that spreads out all around me and my space. Just a joy to experience. Yes, the speakers seem to float the music into my space without any attention or localization of the speaker box or physical presence.

No part of frequency spectrum is out of place or forced. I am sure this has to do with the absence of noise. My music is equally articulate and resolved at low or loud volumes. Music stays controlled and enticing no matter how complex or bombastic the recording.

The ENO filter is passive, not powered, so there is no need of any power supply or plug. This is a huge plus.

Hope you streaming audiophiles find this helpful.

Bill
128x128grannyring

It should be noted that Network Acoustics themselves strongly recommend using a network switch between your internet source and your ENO filter.  I've tried both variations in my home systems (using an ENO filter with and without the network switch) and noticed a much bigger difference with the switch installed.  To be clear, however, the switch + ENO filter was materially better than just using the switch alone.

@lalitk You couldn't get much more clutter free than server with optical out to streamer/usb renderer with optical in to dac.

My system when I am able to use it again:

Wifi to TP Link 6500 wifi extender (initial trial as an option)

Meicord Opal ethernet cable to modded Cisco 2960 switch with lps

Meicord Opal to Project Stream Box S2 Ultra

Mad Scientist Black Magic USB to M2Tech Evo 2/Supply/Clock

Black Cat Silverstar to Dac.

 

The ENO Ag filter is a little out of reach at present, having bought many things over the last 6 months. I’m not wanting to go the optical route, or EtherRegen, but aware my system as it is will need some filtering. Have heard mixed reviews of the SOtM ISO Cat 6. Also considering an Acoustic Revive (either RLT-1 or RL1-GB Triple C).

 

When using my DejaVu server as the Roon core and the Metrum Ambre as the Roon player, I wonder what the effect would be to move the ENO between the DejaVu and the Ambre, instead of having the ENO on the upstream side of the DejaVu where it is now? I would be interested whether anyone else who is running separate devices for their Roon core and player is using two ENOs, one in front of the server/core and one between the core device and the player?

Also, have any of you tried this network switch? Around $300 gets you a linear DC Power Supply and OCXO clock, which is said to be an improvement over the TCXO clock in the Bonn N8 and EE8 switches.  For those who want to spend more, there are more expensive OCXO switches such as this one and this one.

Post removed