Advice for RCA Interconnect Upgrade?

I was a skeptic for a long time. Finally, to scratch that itch, I contacted a vendor and ordered a full set of cables for my rig. In short, I was very impressed. Clarity, sound stage, bass response and accuracy all improved to my liking. I suggest doing the same. Contact a vendor that allows you to return the cables before 60 days. You will need to pay return shipping but that is a fair price to determine if a $1K set of cabales will make a difference to your ears. If I may suggest, buy a set of Shunyata Venom-X RCAs, plug them in and see if you recognize a difference. Most cable makers claim the cables need to be broken in to discern a difference, but Shunyata says this is not necessary with these cables, I believe that to be true since I heard an immediate difference, improvement, upon swapping the cables out with my old ones.

my $0.02

Thanks All.  An interesting mix of suggestions.

My home is literally 20' x 20'.  I call it my "little cottage".  Seven foot ceiling and no basement.  Therefore, my living room(10x12) is my listening room.  Speakers on each side of TV and very little room for optimum placement. Especially those Ultra Towers.  If I could "unbuy" them I would.  When I stated "highly modified" this is what I did.

As you all know, many well established speaker companies skimp on the internals and SVS is no exception.  Very disappointed when I opened them up.  Basic components on the crossover.  Binding post crap.  Wiring type questionable.  I updated the crossover as much as I could and still get them to fit inside the cabinet.  Clarity Caps.  Ribbon and Litz coils.  This was done only on the upper and high frequency parts of the crossover.  The inductors I wanted to use for the bass part are just too big and an external crossover would be needed.  So, yes, probably my own fault for the bump in db in the 4 to 5k range.  I do not have access to proper testing equipment so it was a "guess" .  But I figured anything would be an improvement to what SVS used.

The cheap binding post is replaced with almost pure copper type, the company name alludes me at this time.  Used VH Audio hook-up wire and Cardas solder.  I added dampening to all the cabinet surfaces.

The result was worth the effort.  Not going to bore you with all the blah blah of soundstage and such.

Sure wish I had a dedicated listening room but heck, My rent is only $350.00/mo. and that includes heat and electricity!  That is a big plus here in northern Michigan.

I'm leaning towards Triode Wire Labs.

I have said this ad nauseum: wire is not a tone control. It would be a wonderful world if changing a wire made an improvement in sound quality.

I DO find cables to be effective at seasoning the sound. They are not my first or even second go-to options, but they’re completely effective and legitimate.

The first option is speaker position, the second is room treatment, the third is any tubes in the system...later on, though, cables are another tool. For me.

Only one opinion and should be taken as seriously as those of us that are Zavfino Fans. You need to try them, they have return privileges with a restocking fee.

Also step up the line to the The Fusion - Solid Pure Silver & OCC Copper - ZavfinoUSA

I like their products and you could do a lot worse in my opinion.  

As far as Zavfino is concerned, I tried the Arcadia and they were OK. Way too far from a jaw dropping performance but perhaps a solid choice for around $100-$125 used. I expect their upper tier interconnects to represent similar value. Buy those used. Sorry Zavfino fans for 💩ing on your parade. 

Use vh audio v twist with eti and aeco rca’s...lots out there to try.These have had me satisfied for a long time.The puresonic end on triodes,audience,ect are reasonable $ and have me curious... but i suspect Eti’s are as good as anything out there imho 😉