Implications of Esoteric G-0Rb atomic clock

Rubidium is not necessary for timing accuracy, but it makes sense that a commercial rubidium reference oscillator would pay special attention to close-in phase noise in the vicinity of the main carrier, which is what's improtant in regard to jitter.
To put the frequency accuracy issue to rest, here are the facts. Standard (i.e. cheap) crystals are guaranteed within 100 PPM (parts per million) in the proper circuit. Add another 100 PPM for extreme temperature/humidity and circuit voltage variations. The total is 200 PPM or 0.02% of frequency accuracy. For a 1 KHz signal it will be off by 0.2 Hz. Even an acute dog wouldn't be able to tell the difference...
It's a joke when some manufacturers offer an "upgrade" to a TCXO option. How about upgrade to a low-noise oscillator? I'll take that option any day!

I'm having a little trouble following this, but I wonder if "frequency accuracy" is not being used in the same way by all of the posters above. Just to be clear, we are not talking about audio frequency response, at least as I understand what RH is talking about. Dgarretson's summary is excellent.

Jitter occurs all over the place. It is of no significance except at the real-time A/D process or the real-time D/A process, which is when the distortion takes place.

Drubin: The point that Serus and I are both making is that frequency accuracy means nothing regarding audio quality. It is used by some marketers of digital audio technologies to introduce new numbers with flying colors (they look really good on the ads). However, the point in Jitter is not whether the frequency is accurate, it is however the point whether the SAMPLES are accurate. And that's what I am trying to show in my example: samples can be way off and cause massive distortion at the D/A or A/D process but the frequency can be right on target. Frequency is a total amount of oscillations per unit time. Jitter is how much each sample is off time target each and every time. And with clocks, this can be 33 million times a second. So potentially, a clock can make 33 million little mistakes a second and still be accurate to a fraction of a second within years and years of running.

These two things must be differentiated. And it is important to understand that Bach sounds great, whether the music is tuned to A=440 Hz or A=440.2 Hz. Nobody, not even Bach himself, would ever notice the difference. But I think it's safe to say he wouldn't have liked Jitter.

Liudas

JH's point regarding frequency is that a crystal clock is subject to transient fluctuations in output frequency caused by power supply variations & ripple, whereas the output frequency of a rubidium clock is inherently stable. He states that a transient variation in clock output frequency is "the very definition of jitter." Timing errors in the clock translate directly into a misshapen waveform and amplitude errors in the reconstructed analog signal, as well as introduction of spurious sideband frequencies unrelated harmonically to the original signal.

While I accept the benefits of ultra low-jitter clocks, I wonder whether some jitter in clock frequency is reintroduced in the clock-link cables that connect the G-ORb to the transport & DAC.

I would love to hear for myself the effect jitter has on sound.