I found a set up description in a Stereophile Review of a PBN Montana.
" When he sets his speakers up in a listening room, PBN’s Noerbaek begins by placing the speakers about 2’ from the back wall and about 7’ apart. He then toes them in, finding the proper angle by extending the horizontal plane of the front baffle to intersect the outside rear corner of the other speaker. (This is easy to do with a length of string and a couple of pieces of tape.) Once the speakers are so positioned, they can be moved a little at a time until the optimum imaging is found.
In my room, I was able to get the Montanas relatively close to the rear wall without inducing any boominess. I found that a horizontal separation of about 6.5’ between the inside front corners was optimum in my room, and 16" out from the back wall was fine. The heavy-duty spike feet are essential for getting the most out of the EPS, but shouldn’t be installed until the speakers are close to their permanent positions. Once the feet are on, each speaker can be moved by tipping it back so all its weight is on one spike, then pivoting it around that point. Toe-in is critical if you want to get the best imaging from these speakers. "
1 Measure from the front of the speaker enclosure ( the baffle ) to the wall behind the Speakers and on the centreline ( for the sake of uniformity ).
2 Switch off the Subwoofers and find out what the Mains ( L+R channels ) sound like without Subs.
Don’t hesitate to adjust the distance to the wall and between the Speakers as well as the distance for listening position.
You are adjusting for both power response and soundstage - the image should extend beyond ( outside the speaker positions ).
Note the difference between the initial setup and how the reviewer positions the
L+R channels.