Musical Surroundings Phonomena II+ -OR- Moon 110lp v2 -OR- Parasound ZPhono XRM Phono

thanks DeKay, I will definitely look into these options. I "thought" the Rega feet do some of the/a decent job of isolation. 

One should really have their TT on a good solid foundation and isolated from foot falls and vibration. Lack of detail is more a cartridge issue, alignment, VTA (nonadjustable but you can get shims for Rega TT)  tracking force all plays a part. 

Jerry:

I'll add keeping the stylus clean to your list.

I've been using the original Magic Eraser for years now, but my arm has an up/down lever (don't think I would try it manually).

Before that I was using a travel sized ultrasonic toothbrush with replaceable batteries (just touched the stylus with it) and a stylus brush - the Magic Eraser works just as well.

A dirty stylus and/or groove wear on LP's is a common cause of what the OP describes.

Grisly:

What cartridge do you have (see a few options supplied by Rega with the deck)?

The light/rigid approach is geared towards draining vibration off/away from the Rega (not isolating it).

This approach also works with my sprung/suspended TT as well as the CD deck.

Instead of buying one of the expensive recommended light/rigid racks I purchased a bolt together steel rack and mig-welded it into a one piece "rigid" unit.

I also ended up with zero fill in the hollow legs after experimenting, but the rack is located outside of the living/listening room.

DeKay

DK: you mean this?

I have the Elys 2 MM. with maybe 300 hours on it.

I thought my Rega feet had a spring but it's just a piece of plastic. Short term I couldn't squeeze in another piece of furniture, so I am thinking I could put rubber under it or isolation feet. like something under $35 and see if it makes a difference.

I did listen again to Dylan, ELO and Van Morrison with 3 seconds delay on CD and vinyl and found the vinyl to lack some detail. I cleaned the stylus and.... I'd be wary of aligning it, just yet, I would need to learn how.

Yes, that is it (ones sans any added cleaning agents).

My original pack of them has a finer grain than later one's, but no-one has complained about the later variation(s).

I stick a slice of it down to a small piece of thick paper, but have a tonearm up/down control like the one in the following video.

I would not trust my doing it solely by hand @ this point in time, but I'm 68.

Lot's of info here in the forums on the best way to use it.

DeKay