More Bass

@navyachts picture speaks a thousand words. is there a way you can add a virtual system with pictures of room and current set up?

That will help with proper recommendations with your current and future setup. 

@mike_in_nc - so how do I go about doing this "Measuring" I once downloaded some room correction software and purchased a microphone off Amazon. I found the whole process beyond me and sent the microphone back. I would need help with this, for sure!

@audiorusty - my apologies, there are two 10" woofer, it's the mid-range that is 7"      There is bass and I'm not looking chest thumping stuff, it just doesn't hit as hard as I would expect. Maybe it's the sealed box that I'm not use to? I will heed some of your other advice and get back to you. Thank you. 

@arcticdeth +1

@audphile1 - yes, working on that. I'm just trying to finish up a major remodel which has led me to tear my rotator cuff, so it hurts to blink at the moment. Going to take a bunch of pain pills and maybe over the weekend, I will try to get that done. 

Two things that strike me about this thread.  One, Legacy speakers are never light on bass.  Two, they also never sound bright (with ample electronics as you seem to have).  I have owned Legacy speakers for 25 years - exclusively.  I've had OG Classics, OG Focus, Silverscreen II, Silverscreen HD (currently own) and Focus SEs (currently own).  When I had crappy electronics back in the late 90s, the Classics could definitely sound a bit harsh.  But they produced very solid bass even with said crappy gear.  I think my amp back then was an Acurus A125X5.  It was cheap but still allowed the Classics to thump pretty hard.  My room was not as big as yours since I rented back then.  But it was open into the dining room and kitchen, so it wasn't too far off.  There was also a slider off to the right going out to a balcony.  And it's coverings were not sound absorbing.  The ceilings were also only 8'.  These probably explain most of that harshness.  How is the room if you walk around and clap? (I recommend doing this when your wife is running an errand :D).  I'm guessing it will echo like crazy...

Room layout and speaker positioning is key and I see that several have mentioned that.  You don't even have to go wild with placement - since I know you are not able to.  A few inches could make a drastic difference.  And don't over-do toe-in.  That is a common mistake.  Mine fire nearly straight out into my room.  Maybe 2 to 4 degrees at the listening position which is 9' away.

Since sound panels or diffusers aren't an option for you, there may be little you can do to tame the room's harshness.  But again, speaker positioning can help to a degree.

@audiom3 I agree with your statement about the equipment, I really have my homework cut out for me with this room, just not sure what I can do about it.

>> how do I go about doing this "Measuring" <<

Well, either you do the work learning to use OmniMic or REW or something similar, or you don’t. There are no special tricks; it just takes doing it a few, or a few dozen, times. There’s quite a bit online, especially for REW. Besides the mic and software, you need a standard mic stand (about $35 last I looked).

Measurement is cheaper than most audio things (especially exotic cables) and has a better payback than many audio things, but it has a little DIY in it and is not something one can just buy and enjoy. It’s not for everyone. But I think you’re probably up for it.

If you have a Windows laptop available, I’d recommend OmniMic2, which I found easier to set up and learn than REW. But thousands of audiophiles use REW every day.