@markmuse it is on Linear.
Interconnects for Pass Labs X260.8
What balanced interconnects are you using with your X260.8 or X350.8?
Looking to potentially move on from my Acoustic Zen Absolute Copper XLRs. While they worked wonderfully with lower power amps I had with their plump bass, including the XA30.8, I find them (suspicion at this point) to be too much of a good thing with the X260.8.
What ICs would have the same natural tone but have better clarity and faster bass?
Gear (in my profile as well):
Bricasti M3, Wilson Sabrina, Pass XP22 preamp, X260.8 amps, Audience AU24SX speaker cables. Amps plugged into outlet on a 20A dedicated circuit.
Thanks in advance!
- ...
- 41 posts total
I own the Pass Labs X260.8 Mono Amplifiers (2). I am using the Canare L-4E6S, Star Quad XLR Cables. I am very happy with the sound.
https://www.amazon.com/gp/product/B074Z3J3T1/ref=ppx_yo_dt_b_search_asin_image?ie=UTF8&psc=1 |
@firstonetallguy good cables. I used them years ago but they don’t unlock the full potential of these components. When I upgraded to AZ the difference was not small. That was when I had X250.5 and Dynaudio speakers. That system was on a level or few below what I’m running currently. |
I run Iconoclast UPOCC Gen 2 from my M3 to A Coda CSiB integrated. It will run you 2k but they will pay shipping both ways with a 30 day trial. A big step above Audience SX which it replaced. You have to get 5 ft though as it is a stiff cable. They will custom make the orientation for you. |
| Post removed |
- 41 posts total