- ...
- 26 posts total
Transcription table....I’ve got some old 16" dia. discs bought @ a Habitat auction, ’just because’... *S* @mijostyn , 👍, great DIY hack, but I’d treat the center hole after counter-boring as well..... ...and the ’lazy’ daemon on my shoulder *yawns* and sez "eBay....40$ + customs v. all that f’n ’round...🤨." @kingsleuy ...sharp eyes, guy....;) *G* But 1.5 mil is 'thin'...*whew* |
@asvjerry , Da. 16" is right. OP must be refurbishing an old broadcast table. And, treating the spindle hole with Loctite also a good idea. 18" fine also. @autospec , I just thought of another way to do this that is much less intensive. Get the cork roll and the 7.2 drill. Somewhere near the center of the cork place the cork between two flat pieces of wood and drill your spindle hole. Treat it with Loctite. Get spray contact cement (Home Depot). Clean the surface of the platter with brake cleaning fluid. You will want to mask the platter. Spray the surface of the platter and one side of the cork with the cement. Let it dry for three minutes. Gently bend the cork into a "U" shape with the spindle hole directly in the center. Place it over the spindle hole and roll down one side at a time being careful not to leave any air bubbles. Trim the cork so it overhangs the platter by around 1". Now comes the tricky part. Use a piece of wood as a bridge, a two by four about three feet long will do. Place the ends of the wood on stacks of books or bricks or whatever is handy so that the wood hovers over the platter. This is to brace your hand. Take an Exacto knife with an 11 blade (the pointed one) and holding it like a pen place your wrist on the bridge and turn the table on, it's slowest speed. Lower the tip of the knife into the cork at the right diameter keeping it oriented on the tangent or it will skate one way or the other. Press down firmly and let the platter take a few revolutions. Peel the excess cork away. You can clean any glue off with a rag and lacquer thinner. |
- 26 posts total