What is too much damping? The Cube Audio folks used solid state amps at a show I attended. I assumed that they have a higher damping factor than most tube amps. If they do best with low damping factor, wouldn't they shine best with tube gear?
Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
----------------------------------------
Parameters (from Cube Audio):
Power: 40 W
Efficiency: 92 dB
Frequency response: 30Hz - 18kHz ( 6db)*
Dimensions: 30 x 50 x 105 cm
Weight: 40 Kg
* Frequency response may vary and depends on room size and accompanying electronic equipment.
- ...
- 1567 posts total
@larryi Cube Audio primarily pairs their speakers with Tekron 2a3 SET tube amps for shows and demos. Sometimes the US Distributor uses First Watt SIT amplifiers at shows. Very unique solid state amplifiers designed by Nelson Pass that behave electrically and sonically like SET tube amps. The SIT-1 and SIT-2 have an output impedance of 4 ohms and a damping factor of 2 while the SIT-3 has a less ideal .25 ohm/30 DF rating. This review explains in all thoroughly: https://www.6moons.com/audioreviews2/cubeaudio2/6.html |
@dlcockrum @whitestix @charles1dad Thanks! |
I noticed a comment on the previous page regarding Refined Audio, so I just checked. They continue to import and represent Cube Audio. In fact, in case someone is interested: a Nenuphar BASiS is listed at a healthy discount 😊 here >>>> Refined Audio Cube Audio Speakers
|
- 1567 posts total