another rookie question - preamp or or power amp

Here’s a bit of a change in direction from what people are suggesting.

I would consider an Adcom GFA-545 power amp.

Inexpensive to buy. Well designed circuit. Big power supply. 
 

I picked one up so I could have a higher power amp on hand for driving my DIY speakers. All my other amps are below 30w.

For the couple of hundred bucks you’re gonna spend on it, it’ll provide a lot of joy.

I had 2 very good integrateds amps, the KRELL K-300i and the CODA CSiB, I went separates with CODA 07x + CODA #8 replacing the CSiB. I also went Benchmark LA4 + KRELL Duo 175XD replacing the KRELL K-300i.  While the integrated were very good and I was more than happy with them. The separates were much better to my ears and I will not go back to an integrated.

The only time I took a penalty going separates was going from a $7k RAAL VM-1a tube amp (with preamp) to a Schitt Mjolnir preamp ($1100) and Schiit Aegir amp ($800). If the VM-1a was 100/100 the Schitt stack on my headphones was 90-95/100. Very close for a lot less money. I am listening to them as I write this and it is a killer combo.

These days when I need some audio gear I always think about checking out Schitt to see if they have a solution. It will most likely sound very good and be cost effective.

@grislybutter 

Hey Gris,

Your question may already have answer.  Double check if the preamp in your integrated is always in the circuit.  Meaning,  if you put another preamp in the chain, it will still go through the preamp in the integrated.  My Hegel, for instance doesn’t have a dedicated preamp input and will run the external preamp through it’s preamp and then to the amplifier.

All the best.

@curiousjim 

Wow. Exactly, Thank you!

I have been looking at the different combinations and wondered why some integrateds have the main input and the preamp our and then connected with a dongle vs. just the preamp. That's how ignorant I am. I don't have a main in.

@grislybutter

Unfortunately, upgrading "one tiny step at a time" is not a strategy that is likely to keep you satisfied in the long run. I dare say, everyone here, at some point, has experienced situations when we wanted to upgrade but simply couldn’t afford to spend what it would take to make a real improvement. 

It’s not clear to me which aspects of your system’s presentation you’re seeking to improve. If you simply must spend that $400 now, it’s possible a power cord upgrade or vibration control could yield some noticeable benefit, depending upon what your goal is.