Bananas rule, spades drool. End of discussion.

@lanx0003  Exactly my point.

Of course, I don't' really care what A'goners actually DO in their system.  Just wanted to express my experience and why this is a banana friendly household.

PS - I like crimp-on spades for barrier strips a lot.  The main difference there is the spades are soft, and screwed down. They're perfectly fine inside equipment.

@hilde45  Bananas are not actually meant for gorillas.  🤣

So what do you use instead??

Hey! I resemble that remark!

I have some cables with spades. I have some cables with bananas on them. When they break, I strip the wire and thread them through the hole.

My point is that it bananas can break. My AQ cable now lacks two of four bananas.

I use one-piece BFA style banana plugs (not really banana plug but fit into the same female connection).  They fit tight, stay tight, and are one piece.  Tranditional banana plugs are a challenge because they have to be either gold coated steel (try a magnet on the cheaper ones) or they are solft and can loosen up.  They are also multiple pieces and I've had them pull apart on my.  

Spades, in addition to what has been said, can sometimes be pulled sideways into a short.  

BFA rules.

Jerry

Well, I usually don’t use any connectors for speaker cables, just some teflon tubing to make a diy 47labs style plug.

Granted, that works for me mainly because I’m using small-ish gauge solid core wires.

For convenience, I sometimes use these hollow BFA bananas; they fit very tightly, are very low mass, have a larger surface area than spades connecting to the socket, and - my spades tend to come loose in my (limited) experience .

They also are very affordable, and I have yet to break one or fail in any way.

I’d love to some day figure out what thread speaker terminals most commonly use for the outer part that holds the spades/cables in place, to use a simple copper nut instead of the usual plastic clad brass things .

My speakers and the amp use a thread that almost is a metric M6, but a tad larger than 6mm; so it's probably an imperial thread size of unknown pitch.

Any hints for an ignorant European? 😉