Very simple — just run an interconnect from the Marantz front L/R preouts to the home theater bypass input on the C12000, and obviously the MCD12000 also gets connected to the C12000 as well and that’s pretty much it (only the C12000 is connected to the 1.2k mono block amps). When you wanna do home theater just choose the HT Bypass input on the C12000 and the Marantz is in control, and when you’re listening to any other sources to the C12000 the Marantz is completely out of the signal path. Hope that helps.
Challenged with Going from Integrated system to separates
Hello,
I have an audio /home theater that is all powered by a marantz 7015 and 4 external amps. In this scenario , I use marantz AV receiver as video processor , and preamp . I have dedicated amps to power up my 7.2 channel.
i have recently decided to go separates and picked up McIntosh MCD12000 as the DAC and C12000 preamp which will feed into a McIntosh 1.2k mono block AMPs for 2 channel audio . The c12000 preamp as bypass mode if I wanted to bypass a video processor for 2 channel audio.
Challenge /question:
how do I put the marantz AV receiver in this set up , so that I can use the marantz for home theater processor ?
- ...
- 9 posts total
Post removed |
Post removed |
- 9 posts total