MAC SS preamp would probably fit the bill. very flexable as well. Used of course.
Solid State Preamp to replace tube unit
I currently own a CJ tube preamp. Ive always owned tube preamps and I would like to get my first solid state preamp.I am fed up with buying expensive hard to find tubes that last 3 months or new production tubes with that not so great sound. I pine for consistency. I probably wont sell my CJ I'll just keep it. My power amps are NAD M23 for the summer and CJ Premiere 12's for the winter.
Since I dont dabble in the solid state world I am not sure what to get. I figure since this is my first SS unit 4-5k preowned??. Some brands I have considered CODA< Pass, AYRE, Classe, Bel Canto, Krell etc. Note: I have tried the Parasound and Benchmark but they didnt do it for me. I dont like anayltical sterile sound. If it is a touch warm/colored that is probably good as I am coming from a very warm CJ tube unit.
Must haves are a remote with balance control. Multiple outputs (XLR and RCA). I have an outboard phono pre. Thank you for reading and for your suggestions.
- ...
- 134 posts total
Below is a link to the tubes that were recommended to me for the Premier 17LS2. I believe they are NOS from the late 60's. This is reportedly a longer lasting tube. It's my understanding the c-j cranks up the juice on the tubes in some of their designs and that's why they have a short life span. This wasn't the case in my PV-14L. Those tubes lasted forever. |
@jimbones Agreed. I was hesitant to recommend it because your original post indicated you wanted to move away from tubes. The two tubes are only in the input stage while the output stage is SS - so it is a hybrid design. I am still learning, but am told that these input tubes will last a long time. I brought it up because I am really impressed with the improvement - although maybe a full SS would be just as nice. This is my first stand alone preamp though and as such I don’t have experience with other preamps. |
@allenf1963 both the MC225 and MC240 are legendary for long tube life. I have some of the original small signal telefunken that were shipped in my 1961 MC240. |
I can’t contribute re: SS for a main system, I prefer tubes. I did have a Tandberg Receiver that I liked a lot, I mishandled it’s input jacks, and replaced it with my one and only Yamaha piece: Receiver CR-1040, sounds darn good and feature full. Hmmmm, sounds like you have been changing tubes too often, leaving it on too long, warming it up too long, need a tube tester to have confidence in your tubes, perhaps lost confidence in the preamp’s innards ........ perhaps have a pro overhaul it. A set of tubes should last thousands of hours, and an inexpensive tube tester keeps you from guessing if you suspect something. https://www.conradjohnsonowners.com/viewtopic.php?t=911 IF you want a unit without remote and/or balance, you can use a Chase Remote Line Controller RLC-1: either 4 sources directly to it, or sources to preamp, use tape or processor loop for the RLC-1. You MUST have the remote, no controls are on the unit. Here’s a new one Dead quiet,There is simply no evidence of it’s existence except you get wonderful remote power, volume, balance, .... Oh yeah, it has automatic and progressive fletcher munson bass boost for very low level listening, I've got 3 of them in use and a spare. Office used just for remote power, Luxman has remote volume, I take a short hike to change inputs, leave it's balance where I set it. Garage/Shop, via Yamaha Receiver's Processor Loop for remote volume and importantly, mute. Main, between tube preamp and tube integrated amp for remote system power, remote volume, remote balance, mute: lets me use my beloved vintage McIntosh mx110z tube preamp with no remote features.
|
- 134 posts total