Thickest Power cord with Power distributor?

@miracle1980 power quality depends on (too) many things.. first I would recommend to test outlet point by plugging vacuum and lamp into it, and check if light dims when vacuum motor turned ON.. if you see no “visible” IR voltage drop, then few hundred milli-ohms less resistance power distribution will reduce voltage ripple inside your amp lil bit.. if light dims, - then going thick wiring options way will not help much..

Thanks all for the comments!

At the end I tried the 2 cables, from wall to Power Conditioner (Ansuz C3)... and the differences were very minimal.

I felt like the Zavfino was more powerful (higher volumes perceived) and a little bit smoother. Again...these might be just perceptions.

It’s really difficult to switch off all the components...change the Power Conditioner cable...re-start all the components again and compare.

So...I ended up keeping the Zavfino from wall and the Ansuz (P2) connected to the streamer.

The other test might be to swap the cables after one week or 10 days... but, do I really want to do that?

Probably not :)

Thanks for updating your impressions. So many a thread just gets left hangin'....

Do what sounds best, but the pragmatic approach is thickest gauge power cable into the power conditioner.

@OP,

I see you live in Germany. Voltage is 230V I believe.

From what I have read Germany does not ground the electrical service like we do here in the U.S. Can you shed any light on how the electrical service is grounded in your area in Germany?

In the U.S. we connect, ground, the service entrance neutral conductor at a dwelling unit directly to Mother Earth. Example Ground Rods.

My understanding for Europe is the Utility Power Transformer’s neutral is connected to Mother Earth at the transformer only. Not again there after. At the dwelling unit there is a ground bar in the electrical panel that connects to a ground rod driven in the Earth. All safety equipment grounds connect to the ground bar. That is a stark difference in the two grounding systems. The only reference from the dwelling unit service entrance neutral conductor to the neutral, grounded, connected, to Earth at the utility Power Transformer is through the soil of the Earth. Potentially a high impedance path...

I can’t help but wonder how the shield of a shielded power cord used in Germany functions.

.