My experience was that the cord from the conditioner to the wall was very important...
A not sarcastic question for the power conditioner/upgraded power cord folks
And I realize that there are those that don’t believe in either
Assuming you use a power conditioner and after market power cords, do you feel that the power cord from the power conditioner to the wall might be a limiting or even a negating factor to the performance of the after market power cords that run from the power conditioner to the gear?
The reason I ask is that I was about to embark upon some more experimentation with different power cords and where I plugged them into when I discovered that the aftermarket cords I had purchased before and some recent arrivals are actually a meter shorter than the ones that came with the gear. This doesn’t matter for the amp due to its location, but when I did my last power cord upgrade I ran my CDP and pre into a conditioner so the length for those didn’t matter either, but as I was doing the musical chairs with power cords thing today, I also was intending to run the CDP and pre straight into the wall on separate dedicated circuits, but I found out that I am a tad short on those two.
Which doesn’t preclude me from moving my dedicated circuit outlets up a couple of feet, and I suppose I probably will, but I was curious as to the opinions about the limitations of a power conditioners power cord.
- ...
- 62 posts total
@audphile1 , thanks for the link to the Pangea . . . that would be the quickest easiest. I think in that thread I referred to I asked about if there was such a thing as an "audiophile power strip" out there, and it appears that this one would fill that bill. At the time, it was @millercarbon who suggested I break my "Promethean power Flo" back out and use it for a strip to get everything on one circuit. As far as that little unit, it is built like a brick (that was back when a lot of the stuff was built so you could alternatively use it as a weapon) and they did not make it so access to its guts would be easy. I remember back when my buddy and I both bought one (we were hoping that David Lewis Audio would give us a $ break if we both bought at the same time) they were around $600. Which back in the ’90s seemed like a lot to pay for something to plug something else into, but I was like, "Well, if it will transform my system, it’s only money, and Lord knows I have too much of that . . .". So anyway, I think that the most logical solution is to move the outlets up about a foot and a half or so, and while I am at it, that will give me a chance to reroute the Romex a bit better where it goes down the wall. That was another reason I thought that turning the breakers to two of the circuits off and only using one circuit for all components was--I didn’t totally understand the logic behind dedicated circuits at the time and I have the Romex running too close together. Oh, and as far as the XLO power cord, the mark down on it was incredible, so that’s why I pulled the trigger on that one. |
@kennymacc +1, and this for every audio component. |
- 62 posts total