I have two direct lines, one for my power amp... which is plugged in directly and the other has my power conditioner where the other components are plugged in.
A not sarcastic question for the power conditioner/upgraded power cord folks
And I realize that there are those that don’t believe in either
Assuming you use a power conditioner and after market power cords, do you feel that the power cord from the power conditioner to the wall might be a limiting or even a negating factor to the performance of the after market power cords that run from the power conditioner to the gear?
The reason I ask is that I was about to embark upon some more experimentation with different power cords and where I plugged them into when I discovered that the aftermarket cords I had purchased before and some recent arrivals are actually a meter shorter than the ones that came with the gear. This doesn’t matter for the amp due to its location, but when I did my last power cord upgrade I ran my CDP and pre into a conditioner so the length for those didn’t matter either, but as I was doing the musical chairs with power cords thing today, I also was intending to run the CDP and pre straight into the wall on separate dedicated circuits, but I found out that I am a tad short on those two.
Which doesn’t preclude me from moving my dedicated circuit outlets up a couple of feet, and I suppose I probably will, but I was curious as to the opinions about the limitations of a power conditioners power cord.
- ...
- 78 posts total
That is in line with the above article, and I believe that is @audphile1's philosophy as well. Are your 2 lines on the same phase? I really like that article- after most points he says "Again, use your ears to decide." I never thought of twisting the romex, I believe it is already, but a few more twists sure wouldn't hurt. And going to have to find some silver paste! |
Digital sources poop noise back into the AC line. A good power conditioner makes sense as it not only cleans up the AC going to your components but also cleans up and reduces the noise going back into the AC line. |
I was in this position and I experienced an improvement. I have a pair of 15 amp circuits that have Hubble duplex outlets. All my equipment uses upgraded 15 amp power cords. I installed a Richard Gray power conditioner that came with a very beefy factory cord. After it was up and running I purchased a 15/20 amp Pangea adapter and tried some of my other power cords and noticed a slight improvement. I then tried a Shunyata Venom HC power cable with very noticeable results. The Shunyata cable does not require the adapter. I could tell a greater difference changing that one cable than swapping cables from the conditioner to my component’s. Cheers , Mike B. |
Over the years, during the course of my experimentation with power conditioners and power cables, on several occasions, I tried plugging my amps directly into the wall outlets (with and without upgraded aftermarket audiophile wall outlets). Plugging amps directly into the wall outlet was conventional wisdom years ago, and some/many still abide by it. However, as stated, I found that I still preferred plugging my amplifiers into a high quality, non-power limiting power conditioners, such as my Audioquest Niagara 3000. I’m very happy that you’ve found a method which works best for you and your audio system. I’m also very happy to convey what works best for me. Happy listening. |
- 78 posts total