Skewed cantilever

thats exactly what you need to do, always line up the stylus and cantilever, as opposed to lining up the cart. body.

It may be twisted a bit too, so the stylus is not pointing straight down, but canted a bit to the right. Can this be adjusted for? Is it dangerous to my vinyl?

The stylus angle will change when it is in the groove as oppposed to when you hold it up,the weight of the cartridge body will apply downforce etc..If it looks correct after careful examination and it sounds good it could be o.k.,butI would use my judgement here.If you are worried that it will damage your records,change the cartridge.

Rnm4,

When checking/adjusting cartridge alignment, always:

1) set VTF to where you'd normally play the cartridge,
2) set VTA to where you'd normally play the cartridge and,
3) disengage anti-skating (ie, set it to zero).

Failure to do the above can lead to inaccurate results.

For inspection, try cueing the stylus down onto a mirror instead of an LP. Things will be easier to see. Then use your protractor to align the cantilever, not the cartridge body, as Stefanl said.

You may be able to adjust for a twisted cantilever. Some tonearms have an azimuth adjustment, some don't. Check your tonearm's manual or let us know which arm you're using.

If your arm has no azimuth adjustment it's still possible to fiddle azimuth a bit using the shim technique shown on Wally's site:

http://www.simplyblack.net/WVC/Technical_F_wally.htm

Scroll down to the fourth photo for his clever method. Unfortunately, putting shims between cartridge and headshell can impair their coupling. This could affect sound in negative ways, so it's not a perfect solution.

If this cartridge is new, I'd ask the dealer for a replacement. Vinyl damage is not very likely unless the skew is extreme, but sonic damage beyond your ability to adjust it away is very likely indeed.

If the cantilver is skewed to the right doesn't that mean you do not have enough anti-skate set? Some tonearms are under-set even if dialed in correctly.