Can I clean my records manually?


Well, I know I can but, will this method yield acceptable results for approximately 6 months until I get a record cleaner? If so, I imagine I need a cleaning fluid and some type of a brush or rag. Can anyone recommend a method. Also, am I correct in assuming that the only value an automatic cleaner provides is convenience?

Further, can a dirty record damage a cartridge? I can't see how it would since dirt is softer than the vinyl grooves and lots softer than a diamond.

Am I that ignorant? Please, let me down easy.

thanx
pawlowski6132
Read the Record Playing Rituals stickied at the top of the page. There are tons of ideas on record cleaning there.

BTW, as you correctly surmised, the biggest risk in playing dirty records is not to your stylus. There will be some additional wear but unless you play very dirty records for very many hours the additional stylus wear is likely to be minimal.

No, the biggest risk is to your vinyl, and this is a serious risk indeed. Before I knew better I did audible damage to brand new (ie, not very dirty) records by playing them without cleaning. It is no exaggeration to say that a single play before cleaning can permanently mar a a vinyl LP. This is 100x truer if the record is used and dirty.

Vacuum cleaning is the way to go and, as Flyingred pointed out, it needn't be expensive to get into. Search the archives here and on VA for dozens of inexpensive DIY RCM's.
Your supposition about dirt being softer than vinyl overlooks one extremely important factor, the extreme heat and pressure generated at the point of stylus contact. During that brief moment, those prodigious stresses soften the vinyl so that it is much more vunerable to damage. Plus, the make up of "dirt" varies. You've got fiber & dander particles as well as harder gritty bits of plaster, sand, and who knows what else floating around. I've looked at the detritus on a records' grooves through scanning electron microscope imagery, it varies greatly in composition and size. These variable particles also account for why a dirty record DOES wear diamond faster than a clean record. It's a given that even though diamond is the hardest substance, it can still be slowly worn away. Any increase in abrasive presence during playback exacerbates wear.
Photon is correct. Do the math on a 2 gm tracking force on a .05 x .07 mm line stylus and you will find that the pressures are enormous.
"Do the math on a 2 gm tracking force on a .05 x .07 mm line stylus ..."

Yeah right!! I trust you.

Anyone know a good ratio for Alcohol:Water for the cleaning solution?

thanx
Pawlowski6132, for 20 years I used a home-brew formula (that I'll detail below), but I've found that both the Disc Doctor Miracle Record Cleaner and Paul Fumpkin's Audio Intelligent are vastly superior cleaning fluids that are well worth their cost for the results I'm now getting. Both can easily be used manually using the Disc Doctor brushes, some clean cotton terry cloths and a dish drain. Follow Disc Doctor's cleaning directions for both. You can get a mini-pack sample of Audio Intelligent fluid to try for just $8.

The home-brew forumula I've used in the past is one of the many similar formulas that have appeared in Absolute Sound and in the online forums:

80% Distilled water
20% Isopropyl alchohol (92% pure or better with no additives)
A few drops of Kodak Photoflo as a wetting agent

Followed by a rinse with pure distilled water. The more pure your rinse water, the better (e.g., a distilled water that is also micron filtered and, if possible, deionized; or lab grade distilled water). The Photoflo can leave a residue, thus the rinse step.

I'll reiterate, though: the Disc Doctor or Audio Intelligent fluids will make your LPs even cleaner for even better sound. I'll never go back to the home brew not that I've experienced these results.
.