SDS question

Sameswei...by the "brass piece" ..do they mean the shaft of the pulley? and if so, how do you get oil on that shaft, it being under the wide pulley

Seems like a poor description at best by VPI, but I would assume a Scoutmaster owner would know what to look for.

I had mentioned these very same lubrication needs earlier in this thread, but I cannot take the credit, as I believe this information was provided right here, that I mysekf read once in Agon archives from another user-owner.

These Archives are sure a godsend for all!

Perhaps like my own VPI Motor, acess would most likely need to be gotten under the Motor Pulley, and dependent on jusy how far down the Pulley Shaft that the Pulley is situated may dictate removal of the Pulley?

No doubt attached with an Allen Set Screw, and I imagine the most important thing to remember here if there's a need to do this, is just make sure yu replace the pulley in the exact same manner as it was before.

If the Pulley is removed, this would be a good time to perhaps clean the pulley with a bit of Alcohol, or Windex? Hope this helps, and again, please do let us know how all turns out. Your findings, and information will be valuable to other owners who come along in the future here in Agon. Mark

That's exactly what I did. It's actually 3 set screws, 2 in the shaft, and, once the shaft is removed, a very small one to lift out the brass nut. I then dabbed a swab with motor oil and brushed. Not that simple, but there it is. I hadn't even given thought to doing this since I acquired the motor a couple of years ago, so it was certainly about time.

Thanks again to everybody. I had always wondered how to go about oiling the motor, since there is almost no space between the pulley shaft and the motor base. The VPI manual really should have explained it just like Sberger did!

Cheers.

Tom