2. analog
  3. 1225265825

Help all ye Triplanar Gurus

I received my Triplanar VII U2 from Singapore over the weekend and I may have screwed up big time while mounting the arm.Basically, the screw that adjusts the height of the cueing platform broke in the hole with the screw head coming off,with the result that if I use the cueing platform to lower the arm on the record it seems to descend from Mt. Everest. Manually lowering the Lyra Skala on the record is not good for my health.
Have sent a mail to Triplanar and also the Dealer(Audio Note, Singapore).
I doubt if any A'goners have experienced a similar situation but there is no harm in asking.You have to be particularly cretin like to have achieved what I have done.
Am also unable to align the cart using the Best tractor supplied by my friend Yip in Hong Kong coz the mounting holes on the wooden armband are a bit askew. This can and will be resolved.
Will appreciate any help/ advise to lift my deep depression.
Many thanks
128x128sunnyboy1956
dan_ed
2,451 posts
 
Mark,

you are making several assumptions. This thread is not supposed to be locked. It is expected that this adjustment be made for each setup. I would bet that the OP went a bit overboard when snugging this screw back up.

You all should see the tiny, tiny allen set screws that used on a Basis Vector for different adjustments. One can easily strip out the walls of the screw or the tiny allen wrench supplied by Basis.

This is all part of learning to do things yourself. And there is a certain amount of mechanical aptitude that goes along with this.
stilljd
161 posts
 
FYI

Just for extra information on extracting broken screws. They make left handed drill bits (McMaster Carr or MSC Industrial Supply). If you have to drill out a screw for any of the aforementioned procedures, use a left handed (the spiral is opposite from what you normally see) bit turning counterclockwise in a drill motor or hand drill. Most of the time the drill will hang a little on the screw as it starts to penetrate and back the screw right out.

For the little delicate work like your describing, they also make pin vises. A small, hand held chuck for tiny and delicate drill work.

It won't help Sunnyboy because of his location (hard to access US Supply houses), but might come in handy for you guys.

And yes, I worked as a Tool & Die Maker for GE and tools were my life at that time. All kinds of weird and handy little widgets out there.

Jim S.
markd51
763 posts
 
Hello Dan_ed, Yes, I understand, tiny set screws like this don't stand up to too much abuse. Often, an Allen Wrench has to be coaxed to fully seat into the screw before one applies any pressure.

I'm not sure about the TriPlanar, having never owned one (yet), but these screws may not be Stainless Steel, so even more care must be excersized, being a softer metal.

Wise suggestion about the left hand drill bits, and hopefully, our friend here will find the right person, and that he can carefully extract the bad screw.

Please keep us posted my friend how this all turns out.
I know it's a magnificent arm, and that you're wanting to enjoy it. Mark
dan_ed
2,451 posts
 
Stainless Steel is really not that strong either, but that is beside the point.
sbrown
148 posts
 
Stainless can be strong if you pick the right alloy and heat treat.
More to discover