The ones that screw into the table replacing the VPI feet are the 1.5 1/4-20 thread ones. I suppose that you could use the unthreaded ones if they are the right height. You can use them either way but I have found that their cups improve the sound. In fact, their cups do a good job under standard VPI feet. At about $35 for 4 + shipping I think they are a worthwhile improvement , I use them under mine. I liked their products so well that I became a dealer for them, use their rack also. Their prices aren't cheap but they are not outrageous and they work just as they say they do. I don't mean to imply that there aren't other good products out there, these are the ones I am familiar with.
VPI super mini feet under VPI Scout ??
I decided to purchase the Super Mini Feet to try under the Scout. I had to put a platform under the power supply to raise it up (mini feet are not that mini)and the power cord makes the motor sit at a funny angle now. My custom dust cover clears the feet no problem.
This may have been money poorly spent as I don't notice any discernible difference over the stock cones. Perhaps the Scout does not have enough mass to properly load the mini feet?
The TT is level and sitting on a rigid platform. Set-up is Scout/JMW 9/Linn Adikt cart, Simaudio LP 5.3. TT was set-up by a knowledgeable vinyl head so I don't think that's an issue.
Has anyone out there tried this? I'm thinking I should have just upgraded my cartridge to a Shelter 501 instead. Thoughts?
Cheers
This may have been money poorly spent as I don't notice any discernible difference over the stock cones. Perhaps the Scout does not have enough mass to properly load the mini feet?
The TT is level and sitting on a rigid platform. Set-up is Scout/JMW 9/Linn Adikt cart, Simaudio LP 5.3. TT was set-up by a knowledgeable vinyl head so I don't think that's an issue.
Has anyone out there tried this? I'm thinking I should have just upgraded my cartridge to a Shelter 501 instead. Thoughts?
Cheers
- ...
- 10 posts total
- 10 posts total