SME V and Benz LP-S


Has anyone mounted the new Benz LP-S on an SME V? The manual for the SME V says it can take cartridges with a maximum weight of 14 grams and the Benz LP-S is 16 grams. Interestingly enough, the SME IV can take a cartridge with a maximum weight of 16 grams. Maybe the difference is in the way tracking force is applied: the SME V uses a spring to apply tracking force and the SME IV applies tracking force by moving the counterweight. The older Benz LP works nicely in the SME V, but it weighs significantly less than the new model. Anyway, I'm just wondering if anyone has successfully used the LP-S with the SME V.
128x128kmccarty
Thanks for the responses. Audioquest4life, do you use the SME V's damping with the LP-S, and if so, how deep is the damping paddle set? Thanks.
@ Kmccarty,

Yes, I do use the damping with the SME V. I have been using the silicon damping fluid every since I purchased the SME V. I keep it about 1/3 to 1/2 full. I have only had to refill it one time since I have owned it, about 4 years now. It is about time I do a refill and perhaps a cleaning, however, I do not have any damping issues. The actual settings for the damping are not that radical. I have set mine to about minimal, I must check to verify, but I do recall using a minimum amount of damping.

Ciao,
Audioquest4life
I just bought this arm , my first with a damping reservoir. I have no idea what damping fluid does , even though i put I'n the silicone. I'n lay terms what is the role of this damping reservoir please ?

Hi Wt4158,

Damping fluid is intended to absorb ambient, non-music signal energy (vibrational energy, in the form of resonance frequencies).

Any non-signal vibration whatsoever can degrade the quality of musical playback. Theory states that silicone's unique properties absorb spurious vibrations, dissipating that energy as heat while letting the music signal pass unperturbed.

SME is one of the very fine tonearm makers; their research dictated the use of silicone as a damping treatment at the 'front end' of the signal path. SME are both deliberate and diligent in their design. They don't offer damping so they can charge more for their arms; it's there with good reason. I would respectfully suggest trying it, and giving it some significant listening time. If you hear no difference, you can easily operate without it, with the knowledge that you tried that path.

This damping option is one way to address the equipment-room interface. In my experience, listeners largely discount the role --let alone importance-- that room treatment plays in a high quality listening experience. My room treatment has cost more than 10% of all my electronics, and has offered the greatest degree of improvement in listening quality, second only to hiring Jim Smith to voice my system.

Hope this is clear and of help. Please contact with more questions if you would like. I am available at Havenhearth at live dot com

Best Wishes,

David