Help Classe CA300 flashing Green Light


Ok, I am no techie and on my own since my husband is traveling this week.
so tonight, I poured a glass of wine, made a fire, turned on the HT, put in a movie and.....
my Classe CA300 goes from blinking red to blinking green and never works.
It was working fine just the other day - no changes to setup.
The manual is worthless.....
any ideas?
Thanks in advance,
Angela
angela100
ok, more data
If I play a DVD, the Classe driving the front speakers doesn't work, but the multi channel amp driving the center and surrounds does.
If I turn off the DVD player and set preamp to radio, the amp and speakers work.
What does this say? I think it says
the digital cable between the DVD and preamp is ok, or the multi channel amp wouldn't work.
that's as far as my patience would allow me to go.
Angela, did you try checking the "basics" i.e. make sure that all of the interconnect cables are tightly connected, speaker cables are all snug with nothing loose or shorted out, etc ???

Since i'm not familiar with the different "flashing colors" that Classe' uses, i'm guessing that the unit is either trying to tell you that it isn't getting any input signal or that the protection circuit has somehow been engaged. Sean
>
Angela, I own a Classe as well, and this has happened to me on rare ocassions. What I did is turn it off, wait a few minutes, and turn it back on. It will cycle through (red light blinking) and then you should hear a "click" and everything should be OK. I agree with you--the manual is pretty worthless. Hope this helps, Jeff
Angela,

You might want to check and see if any of the speaker wires are shorted. This will cause the amp to go into protection mode.
Good luck.