2. analog
  3. 1314386030

ZYX cartridge looking for advises

I did my homework already, was trying to get an answer on many Audiogon forum places, but still few things to clarify. I know how busy you are, would appreciate for helping.

I am looking to buy Airy 3, low output, copper coil, with SB.
Would VPI Classic or Airy with JMW10.5i be sufficient to handle this cart properly (I read that JMW 9 is considered as underachiever for this)?
Would it be “mandatory” to get VTA on the fly, I know you are a big fan of adjusting VTA for each disk/play?

How to be sure that cart is brand new and the blue ZYX securing tape was never removed and reinstalled back/glued or so, how do the original blue secure tape ends are connected together, any kind of thermal press or so?

I would appreciate for your comments.
rokokono
sidssp
1,077 posts
 
I have a Airy 2 with SB on 10.5 (see my system). They work very well together. Airy 3 is very similar to Airy 2. I think it should work well too.
stringreen's avatar
stringreen
6,440 posts
 
The VPI arm is NOT an underachiever. There are those that badmouth it, but if set up properly is a top arm.
rokokono OP
17 posts
 
Thanks to all of you for your comments.
Yes, Mehran has ZYX back and I will buy Airy 3 from him.

The last few big question to clear up are the TNT selection.

Would it be really needed to have "VTA on the fly" adjusting capabilities on VPI turntable with 10.5?
I read that some audiophiles adjust VTA for each LP.

Would Acrylic platter be OK on VPI tables or an Aluminum would be desirable option?

I just want to spend my funds (dedicated to plunge in to vinyl world) wisely.
syntax's avatar
syntax
2,193 posts
 
It doesn't hurt when you can adjust VTA. It is indeed very useful.
How much you will use it, will depend on the records you will listen to (50-60's or Reissues..). Happy listening with your Zyx. It is a good cartridge.
markd51
763 posts
 
Rokokono/All,

Yes, if memory serves me correctly, the ZYX Airy 3 comes strapped in, as well as being screwed to the Base of the Case's Cartridge Bottom Mounting Plate.

The added little Blue Tape "Seatbelt" is no doubt there to safely retain the clip on Clear Acrylic Stylus Guard.

If it is Mehran you are buying the Cartridge from, rest assured that you are dealing with a first rate seller, and the main USA Distributor of the line.

The Cartridge will be brand new, and be assured that Mehran will stand behind you during, and after the sale, if in the event there are any problems. Be comfortable knowing that you are dealing with the best.

As a safeguard, be sure to leave that Stylus Guard on through the entire Mounting process. Once you have it mounted, are certain that all Cartridge Clip Leads are correctly in their right places, and the Cartridge is fairly snugged, and positioned-centrated on the Headshell, then at that point you can remove the Stylus Guard for Cartridge Alignment with a good Protractor.
More to discover