Sumiko tonearm rewire

Hi John,
Thank you for looking at this.
Yes, I think I know what you mean, I fixed some isolation on mine close to the pivot place, that was a challenge, but like you said - go slow and take a deep breath :)

Sorry - what is OE wire?
And one more, in case I decide to do it myself - when you solder - do you think you can solder with gold? I never did it before, just wondering? Otherwise the place where you solder will break the copper flow with whatever it is in the solder, is that right?

Thank you
Anatoliy

Well,
Decided to take the re-wire route and here is the result.
Plunged into BritAudio rewire service, asked before shipping if can be done, the answer was positive.
Now got the arm back not wired with the refund check minus shipping, the note says "Unable to install new wiring in tonearm due to small opening for wire to pass through".
Anybody had more luck somewhere else?
Looks like I have no better option now than take another chance.
Thank you

I have never rewired a Sumiko. So I can add no advice for that part.

1)34awg is only a starting point. There are many of us that believe the smaller the better. I am using 44awg magnet wire, enamel coated. The clarity in the midrange is astounding. I know you said you like a warm sound, but I will address that later.

2)Copper wire is a good conclusion. I have never tried Silver, so can't comment.

3)Silk or Enamel; here is the hard part. The dielectric has more influence on the tiny signal than most want to admit. Silk is the best since there is no cotton coated wire I know of. A silk wrapped wire will have the least amount of dielectric smearing. At this point your need for a 'warm' sound is out the window. Good. Once you taste clarity, you would never go back.

4)Please invest in lead free, silver solder. Mundorf, WBT being two easy ones to get.

5)I will get a lot of grief for saying this next thing. WBT Nextgen RCA connectors (way too expensive, but the best I have used), with the Eichmann Bullets being the next best. IF XLR, the cheap Neutrik 'non' gold plated being the best of that family for me.

6)Keep the wire on the outside of the armtube for now. Try a few different wire's until you find your fave. Don't discount 46/10 Litz wire, cheap cheap cheap, sounds great.

7)Shielding may not be needed. For my system, careful orientation of the wires as they reach the phono pre get's rid of any hum. Non shielded cables sound best to me YMMV.

Thanks a lot, Cousinbillyl,this is really helpful.
By the way, the old Sumiko wires (now gone as I mentioned) were silk coated, which confirms what you just said.
I am actually excited about getting into this, arm rewire I mean, your short intro will be very helpful. I liked the 'do not put in the arm, go external first' idea!
By the way - where did you get the 44 awg wire from, any particular dealer/brand you have in mind? My guess will be doesn't matter but any particular pointer will help.
Best Regards
Anatoliy

I agree with Cousinbilly....shielded wire closes down the sound.