Does the"quality" of jumpers affect the sound?

Jmcgrogan2
All analog audio signals, regardless of their magnitude, are AC in nature. All Audio amplifiers or integrated amps connected to typical loudspeakers are designed to generate amplified versions of the incoming AC (musical) signal. Any DC should be very very low, as this will bias the woofers one way or the other.

in very bad situations, such as blown output devices in the amp, will there be massive DC on the output.

All musical instruments, in their natural state generate periodic (hence AC) waveforms. Drums generate impulses with ringing, but its still periodic.

The speakers require an AC signal or we would not hear much of anything. The transducers vibrate proportional to the AC signal, compressing and expanding the air, which in turn does the same thing to our ear drum.

Does anyone have an opinion as to whether it is best to stick with one brand of cable for bi-wiring?

If your goal is making your speaker sound more coherent, then sticking to one brand of wire is a good idea. I would even recommend making sure that the two cables of a biwire set are very close in design or identical if possible. The importance of this will have a lot to do with the speaker you have.

If the speaker is a two-way design, where the crossover point occurs in the critical midrange, it becomes more important that the two cables are identical or very nearly the same. In a three-way, where the crossover point occurs at a much lower frequency, you can often get away with a less expensive cable for the bass. Be aware that three-way speakers with more gradual crossover slopes (1st order) or a somewhat higher crossover point between the midrange and woofer, will benefit more from a nearly identical or better quality cable to the bass. Or to put it another way, they will show the limitations of an inferior or vastly different cable design used in the bottom half of the biwire.

Davemitchell,

I have a pair of Spendor 1/2e speakers which are a three way design. The crossover points are 3kHZ and 13kHZ. How would this affect things?

Dpac996 and Bob P., thanks for setting me straight. If it is AC then polarity should not be an issue, as the current is alternating 120 times per second. How come there is so much made of absolute polarity then? It doesn't seem to make sense.

Regards,
John

How come there is so much made of absolute polarity then? It doesn't seem to make sense.

Agreed - too much is made of absolute polarity. Relatve polarity and relative phase of signals in the frequency spectrum are much more important than anything absolute.