2. cables
  3. 1246402229

Best cable for Jumpers

Hello all;
This is my first post and would like to start giving my compliments to everyone.
I am asking for an advice about the best cable to make two pairs of jumpers for my B&W speakers. I don’t like the original ones and besides I loss it. I wave a Transparent Super MM single wire. I am not sure but I think transparent doesn’t sell cable without termination and I am sure that buy a set´s of terminated jumpers will cost a fortune. Since I can do it by myself, what cable do you recommend?
Thanks,
Jveiga
joaoveiga
tholt
551 posts
 
07-01-09: Majicjazz
It is always best to use the same brand jumpers as your speaker cables
. I was using Anti-cable jumpers with 47 Labs stratos cabling (whole system). Replaced them with some Stratos wire and the fidelity improved.

whether this is due to cable synergy or not who knows, but an argument can be made for it in my case.
dave_b's avatar
dave_b
3,159 posts
 
Offer expires today:O)
tpreaves's avatar
tpreaves
2,686 posts
 
dave, I think you should give them to him in honor of the fourth of july
dave_b's avatar
dave_b
3,159 posts
 
He has to ask nicely:O)
dgarretson
2,598 posts
 
I don't know what type of binding posts B&W uses, but if the nuts come off, excellent jumpers can be made from electronics-grade copper foil with holes punched or drilled through to the diameter of the posts. Solderless, minimal metal mass, negligible skin effect, and cheap. Use polyolefin heat-shrink tube to seal the mid section of each jumper.
More to discover