2. analog
  3. 985055351

Start Up Rattle on Rega P3

I have just purchased a Rega P3 and have noticed that when I start it up I get a slight clunking sound while the platter comes up to speed. The clunking dies down slightly but, does not entierely go away and is evident on quite passages. Does this sound normal? And does anyone have any ideas on how to fix it? Thanks "getting back to LP's"
shigojw
david99's avatar
david99
1,467 posts
 
Is the platter level and on the sub-platter properly? If so then you have a defective table.You should hear no noise either on start up or after.
caterham1700
271 posts
 
Remove the belt and clean the pulley and subplatter carefully, wipe down the belt with Talcum powder,cornstarch or Pledge furniture liquid polish and reinstall.Usually the problem comes with the belt dragging slightly in the pulley grooves and riding up and popping back down again.Application of the powder or polish reduces the tendency for the belt to grab & release and ride up in pulley groove.
The start-up rattle is normal, tho. Don't worry about it or you'll go crazy.Rega recommends that you leave the player on and spinning for your entire listening session.

Best,
Ken
jond's avatar
jond
5,857 posts
 
The rattling on start up is normal,if you start the platter with your thumb as you turn on the power there should be no rattle.It also saves wear and tear on the belt and motor.
More to discover